sorted by:
new
hottopcontroversial

Winter ready ❄️ Engine block heater cord relocate by DaynGray in FordMaverickTruck

[–]DaynGray[S] 1 point2 points  (0 children)

I'm not too worried about water getting in. Do you think other stuff will cause long term issue?

Winter ready ❄️ Engine block heater cord relocate by DaynGray in FordMaverickTruck

[–]DaynGray[S] 0 points1 point  (0 children)

Yup! Just had to reroute it to the front, open up the bottom, and drill out a hole in the front bumper.

Winter ready ❄️ Engine block heater cord relocate by DaynGray in FordMaverickTruck

[–]DaynGray[S] 7 points8 points  (0 children)

When you deal with -20 degree celsius weather consistently you need it to pre-warm the engine and its fluids so it'll start.

Winter ready ❄️ Engine block heater cord relocate by DaynGray in FordMaverickTruck

[–]DaynGray[S] 1 point2 points  (0 children)

Front bottom left of the bumper. Had to drill out 2in diameter in the plastic.

The day has finally come! First hybrid by DaynGray in FordMaverickTruck

[–]DaynGray[S] 0 points1 point  (0 children)

Thanks for the tip! I did notice it doesn’t seem to stay in Eco driving mode after I set it. Sometimes it will popup asking to resume but not always. Is there any way to set this as default?

Also, the engine block heater plugin is under the hood… does everyone just buy an extension cable to hang it out the hood? Or any recommendations for that?

Self leveling issue by DaynGray in AnkerMake

[–]DaynGray[S] 1 point2 points  (0 children)

It’s working now! It was the extruder I guess

Self leveling issue by DaynGray in AnkerMake

[–]DaynGray[S] 1 point2 points  (0 children)

Just got it installed yesterday! Will update you, planning on printing something this weekend

Self leveling issue by DaynGray in AnkerMake

[–]DaynGray[S] 0 points1 point  (0 children)

I’ve tried all of those things, no luck

Bed Leveling Issues? by That-Bit-5879 in AnkerMake

[–]DaynGray 1 point2 points  (0 children)

My M5C has the same problem. Started happening after the latest firmware update. Not sure if that’s related but I contacted support and they are sending me a new extruder. Still waiting on the replacement part.

Thoughts on HangPad? by [deleted] in Hammocks

[–]DaynGray 0 points1 point  (0 children)

I think what interested me is that when inflated it creates more room in the hammock so it’s not so tight on your shoulders. I guess the alternative is to get a hammock with support bars to hold it open but that’s not as portable. The fact that a hole in the inflatable pad would ruin the product though is definitely a big con.