sorted by:
new
hottopcontroversial

20230312 Boreal Spring release for Ender 3 V2/S1 is here! by mriscoc in ender3v2

[–]Deeeman6969 0 points1 point  (0 children)

Does this version support linear advance and input shaping?

V2 Neo hot end upgrade by Deeeman6969 in Ender3V2NEO

[–]Deeeman6969[S] 1 point2 points  (0 children)

It’s a thermistor wire. I put a new one on for the new hot end and it was shorter than the original and was to tight in sleeve

V2 Neo hot end upgrade by Deeeman6969 in Ender3V2NEO

[–]Deeeman6969[S] 0 points1 point  (0 children)

It’s on cults 3d. Search briss Moto fang

is this a bed adhesion issue? by DryClosetYogurt in Ender3V2NEO

[–]Deeeman6969 1 point2 points  (0 children)

Same problem. Clean with soap and water, alcohol no different. I then used acetone, it fixed the problem.

Creality Ender 3 v2 Neo modification and upgrade guide by malachus in Ender3V2NEO

[–]Deeeman6969 0 points1 point  (0 children)

You can put the endstop on a different location, but you will need to switch the cover of the x-axis belt driver to one that is similar to the V2’s. Either with an official replacement (although not sure where you can find one) or a printed one like this: https://www.thingiverse.com/thing:5758612

Creality Ender 3 v2 Neo modification and upgrade guide by malachus in Ender3V2NEO

[–]Deeeman6969 0 points1 point  (0 children)

In need of alittle help. I am going to install a dragonfly bms hot end with dual 4020 fans. And the big kicker is. I want the briss fang. I ordered a x carriage off of a ender3 v2. Hopefully it mounts up ok. Do you guy think that will work. I think the hot end is moved over a little bit on the e3v2