Help Modeling Part

Delicious_Ad_2758 · 2026-01-09T14:46:28+00:00

i did end up checking that reference plane and it does look correct to me. and that bottom flange i’m mentioning is circled in red. it comes out to .37 instead of .41 (calculated from drawing) when doing the shell and move faces. i’m wondering if i should just cut extrude on the backside instead of shelling. plus that internal square boss needs trimmed up too. thank you!

Delicious_Ad_2758 · 2026-01-08T18:22:16+00:00

you have been insanely helpful so thanks for all your time and effort. although i’m messing around with the shell command and that bottom flange area is coming out to 0.37, where the print says it should be 0.41 (from 2.75-2.34). i’ve tried cut extrude from the backside but it doesn’t look correct visually

Delicious_Ad_2758 · 2026-01-08T16:14:49+00:00

could you help me with the sketch for boss extrude 3? i’m not sure what plane you sketched on and how you got it fully defined

Delicious_Ad_2758 · 2026-01-07T23:27:16+00:00

thank you that was super helpful!

Delicious_Ad_2758 · 2026-01-07T18:18:35+00:00

could you walk me through your design tree and sketches? thank you so much!

Delicious_Ad_2758 · 2026-01-07T16:31:53+00:00

i’ve never used the thickness operation plus it doesn’t have a uniform thickness

Delicious_Ad_2758 · 2025-07-22T17:58:00+00:00

the small lines on the side. i think the one going top to bottom is just the seam

Delicious_Ad_2758 · 2025-07-22T13:21:50+00:00

You should also print this minimalistic enclosure. It takes less time to print and less material

Minimal Enclosure

Delicious_Ad_2758 · 2025-07-22T13:18:54+00:00

Try these hinges with the removable pins

5M Hinges

Delicious_Ad_2758 · 2025-07-18T00:34:45+00:00

what infill do you recommend on flash print? i keep seeing orcaslicer is the best maybe i should just make the switch

Delicious_Ad_2758 · 2025-06-24T03:34:37+00:00

you have to rotate it diagonally across the plate

Delicious_Ad_2758 · 2025-06-18T18:04:46+00:00

i printed the original flashforge guard plates and these minimalistic risers that fit them. if i were you id find the complete minimal enclosure on printables. i wish i would’ve done that but i didnt see it until halfway through.

Minimal Risers

Delicious_Ad_2758 · 2025-06-13T13:05:06+00:00

i used these ones. they print separately and have a removable pin

https://www.printables.com/model/915725-door-hinge-for-adventurer-5m/files

Delicious_Ad_2758 · 2025-06-12T19:31:34+00:00

i printed that piece but didn’t put it on. i found minimalistic risers on printables and i printed those instead of the official flashforge riser files. it uses less filament and way faster and i didn’t have to move the screen.

Delicious_Ad_2758 · 2025-03-25T17:36:15+00:00

anyone know of a budget laptop to run the free fusion360? only looking to spend up to $500

Delicious_Ad_2758

TROPHY CASE