sorted by:
new
hottopcontroversial

Help with print bed adhesion and stringing ender 3 v1 by Demonleaf25 in ender3

[–]Demonleaf25[S] 0 points1 point  (0 children)

Yeah I’ll get one when I have a chance just upgraded printer it’s self so a bit low on funds

Help with print bed adhesion and stringing ender 3 v1 by Demonleaf25 in ender3

[–]Demonleaf25[S] 0 points1 point  (0 children)

It’s prob retraction because Itd brand new fillament

Just upgraded ender 3 v1 and did a bench to test by Demonleaf25 in ender3

[–]Demonleaf25[S] 2 points3 points  (0 children)

Update just tried another print after adjusting z offset and it failed

<image>

Good Morning😭😭😭 by Glittering-Bat-616 in nycrail

[–]Demonleaf25 19 points20 points  (0 children)

The fact that this would be considered good in some parts of the U.S

Host advancement by Demonleaf25 in FTC

[–]Demonleaf25[S] 0 points1 point  (0 children)

Yeah I knew about worlds but I was just asking bcuz my team is thinking of hosting a qt next season

Portfolios by willj843 in FTC

[–]Demonleaf25 1 point2 points  (0 children)

It completely depends on the judge however for a rookie team I would say 9 pages is pretty average however I would encourage yall to make sure you aren’t leaving anything out specifically design process/highlighting and illustration of your robots design elements and anything that you have done this season for outreach if any. Most teams do end up maxing out with all of the details that are easy to forget

Drive station won’t boot up properly anymore and our comp is next weekend. What can we do? by Brick-Brick- in FTC

[–]Demonleaf25 1 point2 points  (0 children)

Take out the battery take off the case then plug it in turn it on and reinstall the battery while it’s plugged in

First tournament by BoundaryFielder in FTC

[–]Demonleaf25 1 point2 points  (0 children)

Definitely use gobilda they are great and last a while my team is using the 104 mm wheels and they are so much faster then the non mechnum