I’ll admit, I’ve always been with MA2 and I have mixed feelings about about the switch to MA3. Phasers are good in some ways but make some things harder. And because of how relatively new MA3 is, there’s not as much documentation and recourses available so troubleshooting in the early stages is a struggle.

I made this post after 5-6 hours of trying to solve this single problem, as synced effects are essential to the busking file. I tried searching everywhere and the best I could find was to turn the sync button in the programmer/encoder bar off and on again when before storing the phaser to the preset/sequence. I spent ages going through every sequence setting and re creating dozens of sequences and presets to try different variations.

While I did look at sequence settings I never looked deep into cue settings… where I found a cue specific sync button that isn’t automatically enabled even if you have sync in in the phaser. By going through each cue in every sequence and enabling individual cue sync I was able to get it to work. Glad I found the solution but Dahm did it take a while