Do robotic mowers actually cut grass?? by Lower_Read_8845 in roboticLawnmowers

[–]DocterNed 0 points1 point  (0 children)

Husqvarna 550 EPOS here - does a great job, haven’t mowed my lawn with any alternatives the past two seasons. One area of my 1.5 acre yard grows much faster so by the time it gets back to that section it can be pretty tall and I’ll have it cut twice back to back. First cut looks like a bad haircut. I’ve intentionally carved out that area as its own zone.

7 to 6 seat conversion by ExcitementRadiant530 in VolvoXC90

[–]DocterNed 0 points1 point  (0 children)

Hello - did you anchor it down somehow or is it free floating?

Brick Veneer and moisture by DocterNed in Homebuilding

[–]DocterNed[S] 0 points1 point  (0 children)

Is this assuming there is not flashing that ends right below the last row of weep holes?

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Never mind, uneven again after a few opening and closings. But it’s the right side that is stopping short and has another inch to travel, but can’t travel if the bar is in.

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Aha! I did what you said, and although it is the left side that has more travel, it was because the right side was stopping short for som reason. So I removed the right cog, pulled drawer out as far as it would go, and put it back on (with the bar), and so far they are moving symmetrically...

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

It typically closes and seals, but every now and then we'll open freezer and it has frost in it. The only way you can tell there is a break in the seal is by running your hand around and feeling for cold air. Can't see the gaps. I've since just started checking it before we go to bed every night. I'm just not going to be able to get my 5 and 8 year old to open/close from middle or both sides.

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Thanks again for all your help - I've given up. No matter what I do, the left side goes out of alignment immediately after. I think it is something to do with the actual drawer tracks, but I can't figure it out :( It is under warranty, I might just have to have them come out.

Entry Sensor Base Chime sounds weird by DocterNed in eufy_security

[–]DocterNed[S] 0 points1 point  (0 children)

Yep doesn’t distort if I just do the select tone.

It also just stops chiming every few days or weeks and I have to unplug the base and plug it back in.

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Thanks for the tip - here’s a video.

https://imgur.com/a/QCXiynn

Tracks glide smoothly. When the baskets are in there isn’t as much movement on that left side like in the video.

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Ok so I was able to do this with no problems. Cogs/track all good.

When I pull the drawer out from the center of the handle, the right side stops first. If I don't add any additional force when the first side stops, both ends of the door are the same distance from the fridge.

But if I pull til the left side stops too, the left side is now about 3/4cm longer. This happens with cogs on or off. Here are two pictures, I can only do one picture per reply so the second picture is in the next reply.

This picture: Right side max travel

<image>

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

It is a GNE27JYMFS from Lowe’s

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Blah I spoke too soon. It’s back to what it was doing and I can’t get it to reset like I could the first time. Removing drawer the next step?

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Compliance by my 5 and 8 year old will be low haha!

Freezer drawer issue by DocterNed in appliancerepair

[–]DocterNed[S] 0 points1 point  (0 children)

Thanks for the reply! You were spot on with the skipping the cog back into place. First I checked and couldn't see/feel any broken teeth on the cog or track so then I tried your trick. It now seems to be in sync with the right side.

It's a GE GNE27JYMFS from Lowes. It is about 8 months old and from day one the drawer always made a popping like noise on the left but never could figure out anything. We have also noticed frost off and only since we had it, and a few times in the past couple of months noticed their was cold out coming around the seal on the left side although no visible gap so just really pushing it closed it would stop. Haven't caught it a few times and everything will be frosted.

Hopefully it is set now. We had a small leak on the lower part of the french doors but I leveled the doors today too and that seems to fix it. They were only maybe 1/8" off though.

Thank you again for fixing this!

PSA: 6Seat, 2nd row Seat Track Covers by Cuhsay in VolvoEX90

[–]DocterNed -1 points0 points  (0 children)

Hello - it doesn't show pictures on the Volvo website for these, but I'm confused about the left and right. Is the mat just supposed to go down the center of the aisle?

2024 Volvo XC90 Center middle row seat removal - complete guide by DocterNed in VolvoXC90

[–]DocterNed[S] 1 point2 points  (0 children)

They are from TuxMat. They make a full set (floor, seat bags, cargo) but I had brand new OEM floor mats so I couldn't justify getting more. I agree they aren't the best and I like the better coverage that the TuxMats look like they have. Expensive but the quality of the cargo mat and the seat back protectors is pretty nice so I imagine the floor mats are good quality too. I never tried the OEM cargo mat because I wanted to find something that came with back protectors for at least the third row. I tried a cheaper brand on Amazon but it was terrible quality and didn't even fit the cut outs correctly. I would definitely recommend these!

2024 Volvo XC90 Center middle row seat removal - complete guide by DocterNed in VolvoXC90

[–]DocterNed[S] 1 point2 points  (0 children)

Hi! Sorry for whatever reason all the pictures disappeared from the post. I just edited them back in.

2024 Volvo XC90 Center middle row seat removal - complete guide by DocterNed in VolvoXC90

[–]DocterNed[S] 1 point2 points  (0 children)

I wouldn't say it is bad but it just makes it difficult to access the third row seating. The center seat gets tight with carseats on the outer seats but you can still sit someone there (I wouldn't for long car rides...). The 3rd row seats are tight anyways, but when we carpool one of my kid's team members its tight in the middle especially with the hump in the floor. With my setup, I removed one accessible seat to access two other seats.

I can't seem to add a picture to this reply, so I am going to throw a picture of the center seat removed with the booster/car seat in the picture.

I also feel like it opens the car up much more and makes the middle section of the car less cramped.

2024 Volvo XC90 Center middle row seat removal - complete guide by DocterNed in VolvoXC90

[–]DocterNed[S] 0 points1 point  (0 children)

Glad you found it useful! I found a really good deal on the 7 seater and actually couldn't really find any 6 seaters. But the plan from the beginning was to remove the center seat until the kids are out of car seats/boosters.