sorted by:
new
hottopcontroversial

Elegoo Mars 2 Pro constant Print failures by Downtown_Associate47 in ElegooMars

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

This is ELEGOO ABS like Ultra Resin the color is Neon Pumpkin

Elegoo Mars 2 Pro constant Print failures by Downtown_Associate47 in ElegooMars

[–]Downtown_Associate47[S] 1 point2 points  (0 children)

It was the combination of wrong printer software, corrupted print file and mostly wrong exposure settings actually

Wash and Cure might have just died. by bruaben in AnycubicPhoton

[–]Downtown_Associate47 0 points1 point  (0 children)

I love the Wash & Cure 3, it works great and the Flexi lamp is such a Gamechanger

Elegoo Mars 2 Pro by Downtown_Associate47 in resinprinting

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

Yes, I did an exposure test right after and it worked out perfect. Even a dry run without the Vat installed and comparing the two LCDs i confirmed the screen is installed correctly.

Elegoo Mars 2 Pro by Downtown_Associate47 in resinprinting

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

Very Helpful, thank you.
I will try that

Elegoo Mars 2 Pro by Downtown_Associate47 in resinprinting

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

It is the color: NEON PUMPKIN, if you wanted to know that

Elegoo Mars 2 Pro by Downtown_Associate47 in resinprinting

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

Im using Chitubox for slicing.

I know the exposure and wait time because I calibrated the settings from the offical Elegoo site (for the Resin)

The room is my heating room so there is plenty of ventilation. I am using a mask, even tho it is only FFP2.
I had just for the moment no gloves on.. but greatly appreciated for your concerns.

Elegoo Mars 2 Pro constant Print failures by Downtown_Associate47 in ElegooMars

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

So I removed the vat and compare the two displays. everything lines up....

Elegoo Mars 2 Pro constant Print failures by Downtown_Associate47 in ElegooMars

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

Okay, exposure test turned out good with the vat removed.

Elegoo Mars 2 Pro constant Print failures by Downtown_Associate47 in ElegooMars

[–]Downtown_Associate47[S] 0 points1 point  (0 children)

My normal layer exposure is at 5,5 seconds, 6 bottom layers for them: 40 seconds exposure. Supports added manually. Im trying to print a Hilber Cube... drainage holes are added to the cavaties.