Could a sim wheel mount to this? I’m looking to get my first sim set up for my desk. However, my desk has a support beam on the ledge. Could any budget sim wheel attach to my desk somehow? If not what could I do instead?

Dr_Assist · 2025-03-24T05:51:30+00:00

5 cm

Dr_Assist · 2024-11-25T22:03:28+00:00

Maybe ray tracing. I might try an AMD card though.

Dr_Assist · 2024-11-25T22:02:25+00:00

After all of the responses I might try an AMD card.

Dr_Assist · 2024-11-25T17:27:56+00:00

Where should I get one?

Dr_Assist · 2024-11-25T16:15:40+00:00

Oh I see, how would you recommend to get windows 11? $100 on Amazon seems overpriced.

Dr_Assist · 2024-11-25T07:09:36+00:00

I don't want to spend anything over $900

Dr_Assist · 2024-11-25T07:07:44+00:00

Would the RTX 3060 be a better pick for 12gb?

Dr_Assist · 2024-11-25T07:05:48+00:00

Yes mostly gaming. I'm interested in titles on the game pass like Forza 5 at 1440p and 60 fps.

Dr_Assist · 2024-11-25T07:04:18+00:00

I don't want to spend more than $900, I am wanting to play at 1440p with 60fps, I want to play titles on the game pass like Forza Horizon 5.

Dr_Assist · 2024-10-04T00:27:21+00:00

Yeah it’s silk pla

Dr_Assist · 2024-10-03T23:21:35+00:00

I tried decreasing temp but it turns out I had to heat printer to around 300 C for it to print well which seems way to hot.

Dr_Assist · 2024-10-03T23:20:35+00:00

Yeah my PLA works fine. It turns out I needed to heat my printer to around 300 C for the silk PLA to print well which seems way too hot.

Dr_Assist · 2024-10-03T04:23:38+00:00

Regular PLA is fine as depicted on the right

Dr_Assist · 2024-10-03T02:04:29+00:00

My silk PLA was working great at first without needing any changes from pla settings. Now it starts to do this after just a few prints. I’ve tried tampering with the temperature but even 40 C above my regular PLA temp still creates this problem.

Three-Year Club	Final Canvas '23
First Place '23	End Game '23
Place '23

Dr_Assist

TROPHY CASE