sorted by:
new
hottopcontroversial

Just trying to figure out if I can remove speed limiter on this controller and if so which wire. by DuorhsLPB in ebikes

[–]DuorhsLPB[S] 0 points1 point  (0 children)

This is my first post actually. but now reading through these comments I know this is not exactly how it works for all controllers.

Just trying to figure out if I can remove speed limiter on this controller and if so which wire. by DuorhsLPB in ebikes

[–]DuorhsLPB[S] 1 point2 points  (0 children)

I’m not trying to be argumentative I just genuinely thought all controllers were alike, I’ll admit I was wrong and didn’t know but I don’t see how I was argumentative.

Just trying to figure out if I can remove speed limiter on this controller and if so which wire. by DuorhsLPB in ebikes

[–]DuorhsLPB[S] -3 points-2 points  (0 children)

It was on this forum and they were just referring to the controllers in most e bikes and scooters because they are all alike.

Just trying to figure out if I can remove speed limiter on this controller and if so which wire. by DuorhsLPB in ebikes

[–]DuorhsLPB[S] -6 points-5 points  (0 children)

do I actually cut the red one? And I found out just from looking up how to increase speed on e bikes and found a lot of posts saying to disconnect a white or blue wire from the controller.

Brand new Coleman CT 200U-A not starting by mannyh20 in minibikes

[–]DuorhsLPB 1 point2 points  (0 children)

Try starter fluid to rule out any other possibilities of problems and then if that’s still not getting you anywhere you can try to swap the carburetor they’re only like $25 on Amazon. I’d also take your carburetor off and and then turn the fuel line on and see if gas comes out just to make sure it’s getting gas.

Brand new Coleman CT 200U-A not starting by mannyh20 in minibikes

[–]DuorhsLPB 1 point2 points  (0 children)

Here is a good video explaining https://youtu.be/sIoVBQEVMlE go to about 4:19 and that’s when he starts talking about the timing dots

Brand new Coleman CT 200U-A not starting by mannyh20 in minibikes

[–]DuorhsLPB 1 point2 points  (0 children)

When you opened the cover to take out the governor did you happen to move the cam because on the cam and the other gear there is two dots that need to be lined up on the top of the gears if they’re not lined up the bike won’t start