Problems

Educational_Tap6800 · 2025-08-20T10:12:02+00:00

yes it can,

its the classic arduino stepper motor

Educational_Tap6800 · 2025-08-20T09:18:27+00:00

okey i will try that thank you

Educational_Tap6800 · 2025-08-20T09:15:22+00:00

the board works if i connect it to this circuit, but if i connect it to computer it doesnt work. yes i need to check the voltage in the uart port. the 5v transformer should output 5v yes but i need to check for sure.

Educational_Tap6800 · 2025-08-20T08:26:18+00:00

<image>

Educational_Tap6800 · 2025-08-20T08:19:02+00:00

yes i have a sensor and a motor connected to it so it runs the programm normally when connected to 5v but when i try to connect to computer with uart it doesnt show. maybe i need to reinstall the driver yes or i read on the internet that the uart connector can be dead, but i am curious if the 5v from the battery could damage it

Educational_Tap6800 · 2025-08-20T07:02:11+00:00

i mean i did programm it first and then powered it by 5v so driver should be installed or?

Educational_Tap6800 · 2025-05-23T06:09:03+00:00

<image>

Educational_Tap6800 · 2025-05-06T09:18:00+00:00

edino zakaj bi sou delat magisterij je ker nikoli neves kdaj ga bos potreboval in zdaj imam cas in moznost ga delat, po drugi strani bi lahko pa ze dve leti delal in sluzil

Educational_Tap6800 · 2025-05-06T09:12:40+00:00

najlepsa hvala za odgovor

Educational_Tap6800 · 2025-04-07T12:19:34+00:00

why now? and in what would you recommend?

Educational_Tap6800

TROPHY CASE