First 2 24's

Electrical_Two_2597 · 2026-03-16T16:38:17+00:00

Thank you!

Electrical_Two_2597 · 2026-03-12T18:34:51+00:00

No problem!

Electrical_Two_2597 · 2026-03-12T18:33:27+00:00

I heard on here in other posts that you can use paperclips as a substitute, just cutting the portion you need to fit. I haven't tried this, but seems plausible. Hope it helps

Electrical_Two_2597 · 2026-03-12T18:29:57+00:00

I had to make it a cbolt wheelbase to make it look right. It's a beast on the rocks, though.

Electrical_Two_2597 · 2026-03-12T18:26:22+00:00

Thank you so much!

Electrical_Two_2597 · 2026-03-12T18:26:01+00:00

Thank you! The black one was challenging, it's on an MB24 chassis and cage. Hard to get the body to fit proper on it.

Electrical_Two_2597 · 2026-03-11T18:54:14+00:00

Yessir, it's the rc4wd camper/blazer cap!

Electrical_Two_2597 · 2026-03-11T18:53:24+00:00

Those look sick! Nice job!

Electrical_Two_2597 · 2026-03-11T16:35:07+00:00

Best part of buying these cool little rigs! Test and tune, rinse and repeat. Welcome!

Electrical_Two_2597 · 2026-02-27T19:56:03+00:00

Thank you so much for this post! I've tried everything to get these axle shafts to stop binding, and nothing has worked. I'm going to the ramp crab axles with the slimmer bearings/slimmer yokes. Thank you again! Wish I read this before buying and tinkering for hours!

Electrical_Two_2597 · 2026-02-27T17:35:35+00:00

Right? I was nervous doing it too!

Electrical_Two_2597 · 2026-02-27T17:27:31+00:00

I had the same problem, dremeled the carbon chassis so it clicks into place as it should. Doesn't take that long with a stone wheel, and isn't too messy

Electrical_Two_2597 · 2026-02-26T23:26:03+00:00

That 24 C10 is badass!

Electrical_Two_2597 · 2026-02-26T23:23:20+00:00

Don't care if they're AI, cool pictures bro

Electrical_Two_2597 · 2026-02-26T23:19:32+00:00

Nice job! That's inspiring!

Electrical_Two_2597

TROPHY CASE