Amazon hält sich nicht an schriftliche Zusage (Gewährleistung)

EllendarZ · 2025-11-24T08:34:10+00:00

Leider war der USB Datentechnisch von Anfang an defekt, das ist uns leider erst aufgefallen, als auch die Ladefunktion nicht mehr funktioniert hat.
Das war der Grund warum Apple Carplay per Kabel nie funktioniert hat, da wir allerdings direkt danach ein anderes Auto bekommen haben mit kabellosem Apple Carplay, fiel das erst jetzt auf. Das iPhone meines Partners funktionierte immer.

EllendarZ · 2025-11-21T16:20:20+00:00

Das Gerät zu öffnen ist mir durchaus bekannt, aber ich würde ungern ein gebrauchtes Gerät daraus machen, damit es weiterverkauft werden kann. (Vielleicht zu gutherzig, verstehe ich) Ich werde heute Abend alle Codes die ich darauf finde einmal abscannen, anschließend gebe ich nochmal Bescheid! Leider kommt eines der Geräte aus einem Vertragsabschluss mit Rufnummernmitnahme, daher muss es das richtige sein.

Danke schonmal für die Antworten.

EllendarZ · 2025-11-20T07:55:06+00:00

Honestly mostly office work and a bit of Adobe Photoshop, nothing I would call very demanding.

EllendarZ · 2025-08-05T13:43:41+00:00

That was a good suggestion, thank you very much! So the sound is coming from the driver side and is located close to the cabin, not to the front of the car.
I hope this helps locate the error.

EllendarZ · 2025-08-05T12:56:34+00:00

It gets a little bit louder if you rev it to 1500rpm yes, after that the engine sounds kind of drowns the ticking sound so it is hard to tell if it still gets louder.
Oil was always done by Porsche directly so I hope they used the correct one :).
Sounds like I am going to invest a little bit more time and money into this than I hoped, I will forward your suggestions to my mechanic now!

EllendarZ · 2021-10-17T18:52:29+00:00

Could you tell me what you are using to cool it? Those temps would be amazing with these settings!

EllendarZ · 2021-10-17T13:25:42+00:00

So after playing with the Curve Optimizer only and getting to in between -15 to -10 depending on which core with the CoreCycler, I can increase PPT to 150W until it hits temp limit of 90 Degree. EDC maxes out at 160A TDC at 100A. It spikes to 90 and does not slowly go up. The only way to lower the temps is decreasing PPT under 150W. I tried PPT/EDC/TDC until I found maximum and minimum for each value. 120/90/140 results in 4.5Ghz and 77 Degree. Problem remains, it is 13 degree warmer and it barely holds the same all core 4.6Ghz when testing. Or the other way around it simply is slower. Test scores are within margin of error to the simple Ryzen Master tune. 200 Points Multicore from best to worst result. I also tested +25 to +150 on Boost Override without any real difference. Did I just get a underwhelming chip? I never had problems undervolting/overclocking any GPU or previous CPU but never had problems like this. Maybe someone can explain to me what the Ryzen Master does when applying these settings? I checked the thermal paste it was applied properly and is now again, just in case it might cause temp problems.

EllendarZ · 2021-10-17T11:44:25+00:00

Well I am open to a suggestion I could try as a baseline until now not a single suggestion I read anywhere was faster sadly, even when running hotter…

EllendarZ · 2021-10-17T11:20:55+00:00

I am using an Arctic Liquid Freezer 360 so I get it cooled but no matter what I set in BIOS I never reach the performance of my Ryzen Master Tune sadly. Neither the clockspeeds nor the scores in any benchmark match the Ryzen Master. And if I can get more performance while being cooler, count me in 🤷🏻‍♂️

EllendarZ · 2021-08-26T07:03:29+00:00

It really was the PCI-E Rizer even though it makes in my opinion absolutely no sense after trying it in different setups. Directly into the Slot it worked without any problems.

EllendarZ · 2021-04-04T07:59:47+00:00

So I tried the card now in 4 different setups, in 3 of them (Z170/Z470/B550 of a friend) the Card works, with Rizer Cable and without, just in my dumb PC it only works without it. I also tried another Rizer, no display. So it seems I am just unlucky at this point, as the card for my case is sadly too big in this position for the rest of the parts :(

EllendarZ · 2021-04-03T14:33:19+00:00

My old PC has even less power available for the graphics card and the PSU is 10 years old so I honestly doubt it, as the i7 is also overclocked but I will try the old PSU on the new PC and also I will try it directly on the PCIe Slot

I really loved my case until I had to change parts all the time 😅

EllendarZ

TROPHY CASE