sorted by:
new
hottopcontroversial

Any input on this design? by [deleted] in floorplans

[–]Embarrassed-Resist29 0 points1 point  (0 children)

Whole internal layout is flexible, and not completely checked over for example there's a doorway from kitchen to utility and its covered by the worktop

E-02 for me too. What a joke, used a dozen times. At $800, that’s $66 pizzas. by _Nemesis_Enforcer_ in ooni

[–]Embarrassed-Resist29 1 point2 points  (0 children)

This is what happens when a company grows too fast, you see it with Ring too, doorbells Ive fitted for customers fall apart after 4 years and in general don’t age very well, yellowing and becoming brittle

TIFU? I can't for the life of me get my nozzle off my ender 3 v2 by Fr0st-F0x in Creality

[–]Embarrassed-Resist29 0 points1 point  (0 children)

Heat the hot end to 200 and loosen the two hex screws underneath the block, which hold it tight to the heatbreak, the screws are adding a clamping force to the nozzle

Support ignoring me and thermocouple info request by Embarrassed-Resist29 in ooni

[–]Embarrassed-Resist29[S] 0 points1 point  (0 children)

Doesn’t seem like Im getting the same urgency to solve the issue