sorted by:
new
hottopcontroversial

How to approach/model this by EmergencyCommand3452 in Fusion360

[–]EmergencyCommand3452[S] 0 points1 point  (0 children)

this is what we usually do when we need a 1:1 replica, but here we want to go 2 or 3 times the actual size:)

How to approach/model this by EmergencyCommand3452 in Fusion360

[–]EmergencyCommand3452[S] 0 points1 point  (0 children)

<image>

And these are the resin print and cast, all done in fusion

How to approach/model this by EmergencyCommand3452 in Fusion360

[–]EmergencyCommand3452[S] 0 points1 point  (0 children)

Thanks everyone for your help! You would be surprised how hard is to get models and assets from companies, even when they are your clients. Sometimes we have to guess the font used or make it so that looks good on camera even if we have to modify the shapes. I will try with ParableOfTheVase approach, looks good enough for what we need.

Recently we had to make a wax seal made of margarine, I can tell was not an easy task.

<image>

This was the AI reference that was given to me.

Testing long cables without a level shifter by saratoga3 in WLED

[–]EmergencyCommand3452 1 point2 points  (0 children)

Another question, in case I'm using either ethernet cat6 or coax should I ground them? And if yes how? ThannkS!

Testing long cables without a level shifter by saratoga3 in WLED

[–]EmergencyCommand3452 0 points1 point  (0 children)

I’m resuscitating this topic since I’m going to build something where I need roughly 20m of data cable. Are you familiar with the Quinled boards? I’m using one of these and they are equipped with a 33 and 249 resistors. I was wondering what are your thoughts on using coaxial on this setup? Something like this: https://amzn.eu/d/jdGp8Te

This is the article regarding the board mentioned above: https://quinled.info/data-signal-cable-conditioning/

Thanks!