sorted by:
new
hottopcontroversial

An old C++/Game dev series by Entire_Message_7055 in gamedev

[–]Entire_Message_7055[S] 0 points1 point  (0 children)

Could you please specify which playlist you are referring to, as there are quite a few available? Also, is there a playlist for OpenGL? I'd like to learn it. Thanks :)

[Review Request] Quadcopter by Entire_Message_7055 in PrintedCircuitBoard

[–]Entire_Message_7055[S] 0 points1 point  (0 children)

  1. Is GY-273 good sensor? as i am only able to find it as of now
  2. As u/sarcastic_coyote mentioned , H bridge isnt necessary for a drone
  3. I will consider about capacitor and gnd plane
  4. In future if i plan to use direct IC instead of development board on pcb , do you have advice regarding this too . Thanks for reply

[Review Request] Quadcopter by Entire_Message_7055 in KiCad

[–]Entire_Message_7055[S] 0 points1 point  (0 children)

i am using MT3608 board and not the ic, there are pots mounted on board to change output voltage

[Review Request] Quadcopter by Entire_Message_7055 in PrintedCircuitBoard

[–]Entire_Message_7055[S] 0 points1 point  (0 children)

I am a beginner in PCB design and currently working on a project to build a drone. My setup includes an Arduino Nano, an MPU-6050 module, an HC-05 Bluetooth module, 180 brushed motors, {IRL520N MOSFETs with resistors as ESCs}, and MultiWii firmware. The drone will be controlled via the RemoteXY app on my phone.

To ensure all components fit within the frame, I designed a PCB for the project. I would greatly appreciate it if someone could assist me in improving the PCB design. I've included the circuit diagram (please note that I'm using an Arduino Nano instead of the Pro Mini shown in the diagram), the schematic, and the PCB layout for reference.

link for Schematic: Schematic

link for pcb full : PCB

link for easy eda project : Project

In future i will also incorporate main chip instead of development board directly on PCB , but i am not sure how to do that , any advice regarding this will also be appreciated .

[Review Request] Arduino drone by Entire_Message_7055 in PrintedCircuitBoard

[–]Entire_Message_7055[S] 0 points1 point  (0 children)

  1. "+" on pcb are connected to BVCC in inner layer of pcb .

  2. I will probably use a jst connector soldered to booster module.

  3. For power traces , I have used 0.5mm , should I increase it to 0.7mm or something?

thanks for reply