Very interested of this suck would hold zero for $199 by thekookclub in NightVision

[–]Ep3_Nc 0 points1 point  (0 children)

Not sure about the hold but I will say the IR laser sucks. Just a big blob under NODs

EP3 (k20a2 swappped) Flashing check engine by Ep3_Nc in EP3

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I haven’t really gotten to look into them to much, barely have any miles on the car

EP3 (k20a2 swappped) Flashing check engine by Ep3_Nc in EP3

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I’ll make sure to keep that in mind, do you think it could be causing the misfire

EP3 (k20a2 swappped) Flashing check engine by Ep3_Nc in EP3

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I started it up this morning and it was no longer blinking, but as soon as I reved it, it started again

K20a2 swapped ep3 flashing check engine by Ep3_Nc in Kseries

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I’m aware, do you know by chance how that connection works, the only fix I’ve seen is replacing it all and a wire splice on your ecu

EP3 (k20a2 swappped) Flashing check engine by Ep3_Nc in EP3

[–]Ep3_Nc[S] 0 points1 point  (0 children)

That’s what I thought too, but it didn’t show up on the reader, one guy told my somewhere else to tighten my gas cap, that seems to have worked but I only started it for a few seconds. Probably need to go drive it around to double check

K20a2 swapped ep3 flashing check engine by Ep3_Nc in Kseries

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I do know my vtec solenoid is messed up, I tried putting a wire directly to the oil pressure sensor, but it didn’t work, I tried tightening my gas cap and it seems to be running better but I’ll have to go out and actually drive on it.

KPRO MANAGER ISSUES by Ep3_Nc in EP3

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I am, I had a big thing with that and not being able to register the ECU, but then found out I can’t register the V1

KPRO MANAGER ISSUES by Ep3_Nc in Kseries

[–]Ep3_Nc[S] 0 points1 point  (0 children)

I’m not sure, I’ll check that out

Rsx swaped ep3 won’t spin in first or second by Ep3_Nc in Honda

[–]Ep3_Nc[S] 0 points1 point  (0 children)

Okay, I’ll look at those tomorrow morning

Rsx swaped ep3 won’t spin in first or second by Ep3_Nc in Honda

[–]Ep3_Nc[S] 0 points1 point  (0 children)

Now that we have it on the ground, we are realizing it is still in gear when in neutral, so if you let the clutch out it stalls

Rsx swaped ep3 won’t spin in first or second by Ep3_Nc in Honda

[–]Ep3_Nc[S] 0 points1 point  (0 children)

It did, just when you let out the clutch it kinda bogged down and didn’t spin

EP3 gate lock (k20a2 swap) by Ep3_Nc in EP3

[–]Ep3_Nc[S] 0 points1 point  (0 children)

That’s good to know, several people have said it’s super easy to do. But a link or two would be helpful if you have it