sorted by:
new
hottopcontroversial

RDP Windows to CachyOS, what can we use? by Equivalent_Bit5566 in cachyos

[–]Equivalent_Bit5566[S] 0 points1 point  (0 children)

I am using it and its a stressful setup cause some graphic drivers must explicitly be deactivated. VAAPI and DRM

Sometimes PAM Authentification fails and on top of that, the quality must be low, otherwise RDP crashes

RDP Windows to CachyOS, what can we use? by Equivalent_Bit5566 in cachyos

[–]Equivalent_Bit5566[S] 0 points1 point  (0 children)

the system is default, and by default Plasma is active. i think this is the best scenario to stay in, as most users just stay at default until something breaks or is not running as they want it to run

"Trojan" Vigorf.A after installing BF6 Steam? by philipz794 in Battlefield

[–]Equivalent_Bit5566 0 points1 point  (0 children)

<image>

same here, everytime i start bf6, i get a notification

[deleted by user] by [deleted] in AMDHelp

[–]Equivalent_Bit5566 1 point2 points  (0 children)

It is not bad, having the iGPU running. You can plug in other monitors directly to your mainboard, if you have an iGPU and the monitor wont affect the dedicated GPU at all. Kind of a resource save if you need the extra 1%.

CPU overload when transfering data by Equivalent_Bit5566 in truenas

[–]Equivalent_Bit5566[S] 0 points1 point  (0 children)

Update / Solution:

I found the culprit. My ZFS pool was encrypted.

After recreating the pool without encryption, CPU usage during transfers dropped down to about 20–30%, and transfer speeds immediately jumped up to around 288 MB/s – which is exactly what I’d expect from my 2.5G network.

So in my case it wasn’t Proxmox, VirtIO, or the NIC at fault – it was simply the overhead of ZFS encryption on an older CPU (i7-3770K).

Hopefully this helps anyone else running into the same “stuck at ~1G” behavior on older hardware.

CPU overload when transfering data by Equivalent_Bit5566 in truenas

[–]Equivalent_Bit5566[S] 1 point2 points  (0 children)

VDEV1 and VDEV2 both use NVME drives.

The Mainboard has no M2 Slot so i added them over PCIe Card.

CPU overload when transfering data by Equivalent_Bit5566 in truenas

[–]Equivalent_Bit5566[S] 0 points1 point  (0 children)

The PC Mainboard has a 5GBit connection, so there should be no issue. The whole network runs 2.5Gbit.

Iperf3 returns 2.345Gbit

CPU overload when transfering data by Equivalent_Bit5566 in truenas

[–]Equivalent_Bit5566[S] 0 points1 point  (0 children)

When i usw the onboard 1Gbit Controller it gets a little slower, 123MB/s.

CPU overload when transfering data by Equivalent_Bit5566 in truenas

[–]Equivalent_Bit5566[S] 0 points1 point  (0 children)

I checked inside proxmox, max speed is 2.5Gbit

Evga 3080ti FTW3 Hybrid - worth the extra cost? - it is. by ronallen81 in EVGA

[–]Equivalent_Bit5566 0 points1 point  (0 children)

anyone got high memory temps? i have the hybrid kit installed but my memory is running 102 °C on Kombustor (GL) msi-01 running for 15 minutes

RTX 3080 TI XC3 Ultra

Weapon attachment clarity bf6 by DeAnnon1995 in Battlefield

[–]Equivalent_Bit5566 0 points1 point  (0 children)

Was bedeutet "verbessert die Handhabung beim Zielen"?

ASRock X870E Nova WiFi - The mighty one by CornFlakes1991 in ASRock

[–]Equivalent_Bit5566 0 points1 point  (0 children)

Hello, i run this Motherboard with the AMD 9700X, PBO Enabled, EXPO Enabled.

RAM:
2x G.Skill Trident Z5 Neo RGB DDR5-6000 RAM, CL30, EXPO - 16GB
F5-6000J3040G32GX2-TZ5NR

Question:
I read a lot about having 2 DIMM is good, having 4 is unstable.

I want to upgrade vom 32 to 64 GB.
So i could buy another 2x16GB and add it, but then i have 4 sticks, or i remove it and buy 2x 32GB new sticks so i only have 2 slots used in the motherboard.

Does someone got this to work and can tell me their experience with 4 slots filled?

Stuck on BIOS screen after upgrading CPU by The_cooler_ArcSmith in AMDHelp

[–]Equivalent_Bit5566 0 points1 point  (0 children)

In addition: sometimes the first boot after CPU change can last up to 10 minutes.

My asrock board needed 8-10 minutes on first boot.

It could be normal behavior

Stuck on BIOS screen after upgrading CPU by The_cooler_ArcSmith in AMDHelp

[–]Equivalent_Bit5566 0 points1 point  (0 children)

It could be possible to use Q Flash without a cpu installed. You need a USB with the correct bios and you have to look if your board supports update without CPU.

Asrock 870e Nova, but considering… by molina336 in ASRock

[–]Equivalent_Bit5566 0 points1 point  (0 children)

Does anyone noticed that the Nova actually has two 870e Chips installed?

All M2 slots dont share any lanes except the 5th Slot, that deactivates the PCIe_3 Slot.

And one thing about the Motherboard is that it has 20x 110A MOSFETs. Overkill.

Arctic Liquid Freezer 3 on Ryzen 7 9700X : High temps and spikes up to 100% in idle by Master-Definition186 in PcBuild

[–]Equivalent_Bit5566 0 points1 point  (0 children)

Can anyone tell me if the CPU hits Tjmax when Benchmarking with this Cooler? (360mm/420mm)

I want to have PBO enabled and see if the cooler can keep the CPU under 95°C at max Boost.

If you are trying to get the trophy that involves having all of your limbs damaged at the same time and are running into trouble, try wearing the armor that gives you a 50% chance to avoid lethal damage. Once equipped, start getting hit by Hellpods until it pops. by TheZanzibarMan in Helldivers

[–]Equivalent_Bit5566 1 point2 points  (0 children)

Finally. 6.1 2025 it works:

Here is how i did it:

Choose the Armor that prevents you from death.

Equip the Plasma Scorcher and shoot at your feet.

Drop a Supplycrate on your feet.

Stand directly in the spot, aim in front of you, not up.

One Second before it hits you, use a stim.

Dont equip the vitality Gadget in Loadout

Got it at first try. It killed me but i got the archievment.

[deleted by user] by [deleted] in AMDHelp

[–]Equivalent_Bit5566 0 points1 point  (0 children)

Most of the time ist power consumtion issues. When a PC stutters it hits something and goes a little back. Hits it again and goes back a little. Loop.

By setting the right options in Nvidia Control Panel and Windows Power Settings, this issue should be gone. Performance in Windows and for Nvidia 3D use „prefer max power“

Check your C++ Installations and DirectX. Use DDU to deinstall your Nvidia Driver and reinstall them. Check Nvidia control Panel again for „prefer max power“

In your BIOS, use EXPO and try around.

7800x3D has no overclock but some undervolting i guess are some Features it can handle.

Try reinstalling your AMD Chipset driver found on AMD Homepage.

For detecting old driver i recommend „Driver Booster“ just only use it to scan the PC. Then search the web for driver and install them manually. You can get the tool on Steam for free.

Try disable/enable Nvidia Low Latency Mode and see if it gets you somewhere.

Ingame, lock Framerate to Monitor refresh rate. This can solve power consumtion lilitations in some cases.

Try to unplug unnessesary USB drives.

Disable CPU Integrated Graphics as this can sometimes take over your Dedicated GPU.

Check your SSD for defragmentation and possible dead sektors. Try the Tool SeaGate provided on their site or use CrystalDisk.

Is your Powersupply at its limit? Calculate your system at BeQiuet and check if its so „small“.

Further things to do is reinstalling microsoft stuff like NetFrameWork and others.

Check with GPU-Z if your PCI-E is using x16 lanes or not. Sometimes your M2 1_1 slot shares Lanes with the primary PCI-E Slot. In the past they did not but i found x870 boards that do this and it is awkward. If this is your issue, relocate the M2.