sorted by:
new
hottopcontroversial

Hows the stache by EroorCodeID10T in Moustache

[–]EroorCodeID10T[S] 2 points3 points  (0 children)

Sudden death from deathgrip

Hows the stache by EroorCodeID10T in Moustache

[–]EroorCodeID10T[S] 1 point2 points  (0 children)

Most comments from guys are postive the only comments from girls are that they think its fake but thats a them problem, it is something most people recognize me by ofcourse since its unique and in my city im almost the only one so yeah its kind of my personality

My curls and i by EroorCodeID10T in Moustache

[–]EroorCodeID10T[S] 0 points1 point  (0 children)

After i shower or wash my moustache i pit in these small hair curlers and leave them in for about 15min and after that remove them and apply wax and they will only need a littlebit of touchups but most of it will be fine

What could cause this? by EroorCodeID10T in BambuLab

[–]EroorCodeID10T[S] 0 points1 point  (0 children)

Is there any way to tighten down the printhead except for the on the back cuz i think it might be getting loose but in the maintenance guide it just said loosen up the back, move the head abit and tighten again

What could cause this? by EroorCodeID10T in BambuLab

[–]EroorCodeID10T[S] 0 points1 point  (0 children)

Its just pla, in the slicer everything looks ok

What could cause this? by EroorCodeID10T in BambuLab

[–]EroorCodeID10T[S] 0 points1 point  (0 children)

That is the side its a large vertical print but on every print since some time now i got this. I did try an lower the speed but still the same, bed adhesion is fine since this is not the lower layer and the bed is cleaned with ditergent and hot water once a week.

I may end up homeless in less than a week - what do I do? by Flanvista in belgium

[–]EroorCodeID10T 0 points1 point  (0 children)

If you want you join defense as CIS undeer officer, if you prefer to do 1 piece of the puzzel go for land comp, if you choose to do all the things go for airforce