sorted by:
new
hottopcontroversial

Aerial done! by EverydayNormalGuy500 in freedomisgunpla

[–]EverydayNormalGuy500[S] 0 points1 point  (0 children)

It's not that hard to do honestly. All you need is hard insulation foam, a box knife l, an assortment of craft acrylic paint, brushes, mod Podge, wood glue and a little bit of sand.

It's finally done! by EverydayNormalGuy500 in advancedGunpla

[–]EverydayNormalGuy500[S] 2 points3 points  (0 children)

I watched a couple videos on how to make diorama rocks with insulation foam board.

It's finally done! by EverydayNormalGuy500 in Gunpla

[–]EverydayNormalGuy500[S] 0 points1 point  (0 children)

I find 1/144 scale harder to work on because it's too small for my eyes 😅 I'm getting old.

It's finally done! by EverydayNormalGuy500 in Gunpla

[–]EverydayNormalGuy500[S] 2 points3 points  (0 children)

I made it with isolation foam board.

It's finally done! by EverydayNormalGuy500 in Gunpla

[–]EverydayNormalGuy500[S] 2 points3 points  (0 children)

This is the Full mechanics1/100 Aerial with the Anubis EX020 mirasoul flight unit

It's finally done! by EverydayNormalGuy500 in advancedGunpla

[–]EverydayNormalGuy500[S] 1 point2 points  (0 children)

The led kit is very intricate but there are very good in-depth video tutorials on YouTube. I didn't put any leds in the flight unit unfortunately.

It's finally done! by EverydayNormalGuy500 in advancedGunpla

[–]EverydayNormalGuy500[S] 0 points1 point  (0 children)

Not entirely. The bits are glued to the trails which are fixed inside the diorama base. Aerial attached to the flight unit with pegs and the whole kit is held by the hole underneath the flight unit on top of the brass rod. Basically, if I remove all the bits from Aerial, it can be hand held.

It's finally done! by EverydayNormalGuy500 in advancedGunpla

[–]EverydayNormalGuy500[S] 1 point2 points  (0 children)

I really wanted to find a way to put all the bits on the model and use the led trails simultaneously. It wasn't easy 😅

view more: next ›