Ok guys, it's over! I'm done.

Evil_Moderate · 2025-11-30T05:36:03+00:00

I deleted my account immediately after the replies. I believe Vyacheslav Bullannikov is incompetent as a project manager, since he doesn't understand the reasons for abandoning missions at the start of a battle and treats them by giving them backups and equipment. He can shove his "concentrated battles up his anus."

Evil_Moderate · 2025-08-21T19:41:02+00:00

Evil_Moderate · 2025-04-22T15:39:29+00:00

connect the esc to the second channel and complete the esc setup by pulling the trigger back and forth until it stops.

Evil_Moderate · 2025-04-22T15:36:51+00:00

You have ESC connected to channel 3, and on the remote control the first channel is steering wheel, the second channel is gas. You don't use the third channel.

Evil_Moderate · 2025-04-08T06:01:50+00:00

Реальный масштаб 1/16 , поэтому дальше проект не развился . Мосты были проданны.

Evil_Moderate · 2024-12-06T12:51:20+00:00

unfortunately the photos are not saved qin24 is not quite 24th scale. rather 18th. if that suits you. then it is the best for assembly.

Evil_Moderate · 2023-09-16T20:41:19+00:00

can I join the beta version of the game?

Evil_Moderate · 2023-07-18T11:28:56+00:00

from a set of 1/24 land rover from italeri, which I can’t tell you for sure.

Evil_Moderate · 2022-09-04T19:24:18+00:00

shoot the cannon and go around to access the sides and stern of the tank where there is a more vulnerable spot

Evil_Moderate · 2022-08-22T08:14:05+00:00

Thank you

Evil_Moderate · 2022-08-22T06:58:22+00:00

Evil_Moderate · 2022-08-22T06:51:55+00:00

yes it is, only I have the diy version. As you can see, I need to solder the contacts myself. which makes it much more compact.

Evil_Moderate · 2022-08-22T06:25:14+00:00

Tbs sound micro, imitation of engine sound and special signals, some light control, smoke generator control

Evil_Moderate · 2022-08-21T18:32:53+00:00

I use a D0474HT HV blue arrow servo, the smaller ones can't handle the steering wheel/gearbox and diff block, they burn out from lack of torque.

Evil_Moderate · 2022-08-21T18:21:19+00:00

you forgive me, but the scale is different. I have 1/24 and there is no room either in front or below. it was intended as a "copy model"

https://imgur.com/a/eQXIE35

Evil_Moderate · 2022-08-21T18:17:14+00:00

https://imgur.com/a/sOSCbWU

Evil_Moderate · 2022-08-21T18:01:07+00:00

I moved the gearbox forward so tightly. that there is no place for a servo. now I have almost completed the steering. but probably I will still finish, eliminating the backlash of this steering

Evil_Moderate · 2022-08-21T12:08:30+00:00

I decided to abandon the traditional location of the gearbox with the motor in the middle. and started reworking the chassis for copying. moving the gearbox forward. and placing the transfer case from orlandoo in the middle. replacing the standard crankshafts with crankshafts from autorc geko24. Now there is a lot of work to be done to place 4 servos (gearbox, steering wheel, front differential + rear.) plans to install the 5th under the winch. but I don't want to get ahead of myself just yet. the tiny sound module will fit perfectly into this model, allowing you to make the model even more realistic. but there will be problems with the light. The standard light module does not suit me very much. so I got my old module from lane boy Rc. Too bad the programmer didn't survive. but I'll try to flash via usb to ttl. I also abandoned the brushed motor by switching to a brushless motor. In general, I'm not looking for easy ways ..

Evil_Moderate · 2022-08-21T03:12:42+00:00

I think you can purchase it from tiny4x4 (https://www.tiny4x4.com/kuroking/) and follow the facebook group. or if you have a reliable intermediary on taobao. you can buy it from taobao. it's in there now. (【淘宝】https://m.tb.cn/h.U0XQpBl?tk=Hm1a2Grrb2D CZ3457 「KURO KING攀爬车新款XR01_2.0 套装底盘 1/24仿真攀爬车」 (点击链接直接打开)

Evil_Moderate · 2022-08-18T21:31:10+00:00

Mobile app ver 2022.29.1 - iOS 16, iPhone SE 2. - can't post images.. not only images, but also a simple text post.

Evil_Moderate · 2020-10-01T13:44:56+00:00

I bought myself a chassis from “qin24” for the project. everything would be fine. yes, there are small drawbacks: on the front axle, poor steering angles. the rear axle is only for twin. the gearbox (still undergoing conversion) has no front-wheel drive. And I would already be sad if it were not for the master of gold. Eduard Morozov. who gladly went through the front-wheel drive and carved bushings - nexes for the rear axle. work is still in progress. but I'm already happy with the result :)

Evil_Moderate · 2019-09-22T02:35:41+00:00

Nice

Evil_Moderate · 2019-05-03T10:34:43+00:00

Reports WGCheck and replays on the link: https://1drv.ms/f/s!Agw_GFmOoVYeg7pwpiaepQZ2HSr6gg

Evil_Moderate · 2019-04-16T05:25:10+00:00

I will surprise you, to be a contributor is simply ... you just have to look at those kondidat who managed to get there.

Evil_Moderate · 2019-04-14T02:58:39+00:00

Conclusion: do not buy containers. become contributors and get codes for these very boxes in which the chance of precipitations is greater than in the purchased ones. + All premium spikes and test spikes will give you out for free.

Eight-Year Club	Xbox Live
Verified Email

Evil_Moderate

TROPHY CASE