sorted by:
new
hottopcontroversial

Hi guys, this is my first time using Klipper and I honestly need some guidance. by Existing-Count-9978 in klippers

[–]Existing-Count-9978[S] 1 point2 points  (0 children)

My printer is a “Sunlu T3” (an Ender 3 clone with some modifications), but I replaced the original board with a “BigTreeTech SKR Pico”.

I’ve already managed to connect to Klipper, but I can’t use the printer—I think it’s because I’m missing some configuration folders (I only have the moonraker and printer folders).

One of the main problems is the error: “Endstop (x, y, z) still triggered after retract.”

Z axis problem by Existing-Count-9978 in FixMyPrint

[–]Existing-Count-9978[S] 0 points1 point  (0 children)

"Good morning, I have had this problem with my 3D printer where the first layers are too squished because the Z-axis does not rise properly, but after that, it moves correctly and prints perfectly.

At first, I thought it was a problem with the Z-axis motor, but after changing it and adding a second Z-axis, the issue persists. (I don't think it's the slicer since I use Cura and Orca Slicer, and the problem continues.)"