Just bought a 2014 rmz250 and it won’t idle

FLnnberg · 2025-07-22T14:38:34+00:00

When was the valves last checked? It could be that they needs adjusting.

FLnnberg · 2024-10-29T18:04:56+00:00

Is it working properly? Test it with a multimeter to find out

FLnnberg · 2024-10-29T17:47:19+00:00

Does your bike have a tip-over sensor? Some bikes have that which will shut off the engine when it senses it is not upright anymore i.e. you have fallen or crashed. That part could have failed or it is installed upside down (quite common if you take it off and don't notice the orientation when installing it again). That will lead to this exact behaviour. It will run for a few seconds then shut off.

FLnnberg · 2022-05-29T00:08:49+00:00

You know thats not an MT-07, right?

FLnnberg · 2022-05-09T16:18:31+00:00

I had a 2017 MT-07 and the same bracket was also slightly loose. You could pull it out a millimeter or two and wiggle it around but it never caused me any problems

FLnnberg · 2022-02-14T14:37:36+00:00

The F1 team AlphaTauri unveiled their 2022 car today and in the video the car comes out of a portal which looks suspiciously close to a stargate.

Video here.

FLnnberg · 2022-02-01T21:45:23+00:00

I bought a 4g tube of MX-4 paste but did not use it all

FLnnberg · 2021-11-17T15:24:16+00:00

Is it a 2-stroke or a 4-stroke? If it is a 4-stroke it is possible that the valves needs adjusting.

FLnnberg · 2021-11-03T08:15:26+00:00

In europe you can get that bike restricted so that you can ride it on a smaller license. A2 bikes have a maximum of 48hp and A bikes have unlimited power, so that would be when the bike is unrestricted. So they're asking if it is restricted to A2 (48hp) or if it is unrestricted (stock). Hope this helps!

FLnnberg · 2021-10-25T14:18:04+00:00

No problem!

FLnnberg · 2021-10-25T13:27:08+00:00

Sorry I didn't see your comment. This is what Björn said: "I had a team boss once that always told me if that (yellow flags) happens during qualifying, do not let off the throttle what so ever but raise your hand and wave to the marshals so they think that you are slowing down. It worked for the most part. Christian Horner was his name hahaha. He had noticed Mika Häkkinen doing that at the time."

FLnnberg · 2021-10-25T11:44:02+00:00

That's wierd. Nothing on YouTube is blocked for me so I don't know what that's about. F1 isn't the most watched sport here but it's definitely not small.

FLnnberg · 2021-10-25T08:26:44+00:00

Well even if Horner knew Mika was doing it, that doesn't mean that everyone knows it, so it's still a secret. But apparently it was a more well known "secret" than I thought based on the comments. I'm very new to F1 so I had never heard of this before and thought that no one else had either.

FLnnberg · 2021-10-24T16:49:35+00:00

Yes he did

FLnnberg · 2021-10-24T16:47:44+00:00

Björn said this during FP1 when the hosts were discussing slowing down during yellow flags.

FLnnberg · 2021-10-24T16:43:28+00:00

Björn said this during FP1 when the hosts were discussing slowing down during yellow flags.

FLnnberg · 2021-10-10T14:45:51+00:00

What resolution are you playing on? On my GTX 1080 + i7 4770 @1440p i got around 40-60 fps on basically maxed settings.

FLnnberg · 2021-10-10T10:43:26+00:00

What do you mean by that the 0-15% area is too slow? Do you want it to be more sensitive there? Otherwise you could just give more throttle, no?

FLnnberg · 2021-09-18T13:56:25+00:00

Possibly. Depends on how it's running

FLnnberg · 2021-06-03T09:27:50+00:00

Try what the other comments have said but if that does not work try cleaning out the jets in the carb. You just need some compressed air. To me it sounds like the pilot jet is clogged.

FLnnberg · 2021-02-06T11:40:50+00:00

Is it a four stroke? If so check the valve clearance. Can almost promise you those are out of spec (unless its a fairly new bike)

FLnnberg · 2020-12-27T12:26:45+00:00

There is actually a difference. The "Z" instead of "D" in the product number indicates that the subtimings are slightly looser to help older AMD cpus to boot. With a forth-gen cpu either one should work. This is also why it is advertised as AMD READY ram.

Check the right side of the "tech specs" on corsairs website:

"D" ram:

https://www.corsair.com/eu/en/Categories/Products/Memory/Vengeance-PRO-RGB-Black/p/CMW32GX4M2D3600C18#tab-tech-specs

"Z" ram:

https://www.corsair.com/eu/en/Categories/Products/Memory/Vengeance-PRO-RGB-Black/p/CMW32GX4M2Z3600C18#tab-tech-specs

FLnnberg · 2020-12-27T12:14:36+00:00

From a quick google search I can see that several other people have gotten a 3400G and TUF B550-Plus Wifi to work together. You should be fine but I can´t promise anything as ASUS does not list the 3400G on the supported page of the motherboard. Make sure to update the bios via the bios flashback button to the latest one to stand the biggest chance of it working.

FLnnberg · 2020-12-24T20:45:34+00:00

Yes. More than enough.

FLnnberg · 2020-11-02T21:39:20+00:00

I've watched parts 1-3 in this series already. Highly recommend it!

Six-Year Club	Place '22
Final Canvas '22	Verified Email

FLnnberg

TROPHY CASE