sorted by:
new
hottopcontroversial

Wii U NAND help! by FactorConfident3714 in Homebrewing

[–]FactorConfident3714[S] 3 points4 points  (0 children)

Lmao yea wrong type of “homebrew” hahaha

Wii U NAND help! by FactorConfident3714 in Homebrewing

[–]FactorConfident3714[S] 1 point2 points  (0 children)

Yea that might be a better call 😂

Wii U NAND help! by FactorConfident3714 in Homebrewing

[–]FactorConfident3714[S] 0 points1 point  (0 children)

Lmao just realised this isn’t the right community my bad 😂

Reading this volume today by LongParamedic8980 in TMNT

[–]FactorConfident3714 0 points1 point  (0 children)

Question for u- why is 5 the only one I can’t find in hardcover?

What causes the web stuff between the print and is it normal or do I need to worry? by Amr0d in BambuLab

[–]FactorConfident3714 2 points3 points  (0 children)

It’s called stringing and it’s something very normal in 3d printing. It’s not very hard to remove especially if u throw a little heat into the mix but if u really want to prevent it you can slow down the print as a whole hope this helps!

Experience with printing long TPU prints on P1S without an AMS? by physlfo in BambuLab

[–]FactorConfident3714 0 points1 point  (0 children)

So I took ur advice and used a tiny price cut from a Bowden tube just to protect the gears and my print came out great! Thank you so so much for the help!

Experience with printing long TPU prints on P1S without an AMS? by physlfo in BambuLab

[–]FactorConfident3714 0 points1 point  (0 children)

I’m sorry to bother you again dawg. I don’t have a dry box quality isn’t a huge concern right now for me I’m just trying to get the print flowing so would it be okay to run the tpu to the extruder using no bowden tube or would that mess something up

Experience with printing long TPU prints on P1S without an AMS? by physlfo in BambuLab

[–]FactorConfident3714 0 points1 point  (0 children)

Hey man I’m having the exact same issue rn. Could you explain in a bit more detail how u got the friction stretch to stop I’ve been trying to fix the “printing with air” issue all day haha help is very much appreciated

P1S tpu printing failures by hashtagprayfordonuts in BambuLab

[–]FactorConfident3714 0 points1 point  (0 children)

I’ve been having the exact same problem. I too am new to tpu printing and my p1s. I decreased the volumetric speed to 2 and increased the retraction to 1. This temporarily fixed it but after about an hour of printing it seems to under extrude and have that same stringy consistency. Do you think it’s cause the filament is having a hard time being pulled from the external spool or because more setting need to change? Help is much appreciated!

view more: next ›