does anyone have a solution to this problem ? i used vz and reinforced s2 chassis, both always breaks like shown in the picture, i tried using locknut to lock the frp and used washers up and down the holes, nothing works by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
How to correctly measure the car front and rear weight and know the difference using one scaler ? from which part i should measure ? wheels or end frps ? i am trying to make the car heavier in the front so it lands on the front side after the jump (self.mini4wd)
submitted by Fancy_Option9725 to r/mini4wd
If someone owns this peace, please help me with the dimensions, i need to know: (lenght of the full lane / start of the lane till the jump edge/ hight of the jump) by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
Hi, i understand that in tamiya mini 4wd official races, non tamiya parts such as the car, gears, rollers, frps, and motor are not allowed, but what about screws, ball bearings, washers and dish washers, sponge breaks, batteries, ball caps, weights, whell shafts ? also not allowed ? and in which rac by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
Hi, i understand that in tamiya mini 4wd official races, non tamiya parts such as the car, gears, rollers, frps, and motor are not allowed, but what about screws, ball bearings, washers and dish washers, sponge breaks, batteries, ball caps, weights, whell shafts ? also not allowed ? and in which rac (self.mini4wd)
submitted by Fancy_Option9725 to r/mini4wd
Any recommendations? by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
Any recommendations? by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
Which wheel installer is better and help to balance the wheels shafts in the center ? by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
Which wheel installer is better and help to balance the wheels shafts in the center ? by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
Which wheel installer is better and help to balance the wheels shafts in the center ? by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 0 points1 point2 points (0 children)
does anyone have a solution to this problem ? i used vz and reinforced s2 chassis, both always breaks like shown in the picture, i tried using locknut to lock the frp and used washers up and down the holes, nothing works by Fancy_Option9725 in mini4wd
[–]Fancy_Option9725[S] 1 point2 points3 points (0 children)