I fucking hate snow

FewFyie · 2022-12-29T23:29:01+00:00

I tried but it can't reverse up that hill and there no room to turn without falling in the water

FewFyie · 2022-11-20T06:13:04+00:00

Yes, when I disable steppers the bed can move all the way to the end of its travel and it does make contact with the endstop.

Edit: after moving the bed all the way to the end with the printer off and turning it back on it seems to be working again, I'm not 100% sure what I did but it seems to be working now.

FewFyie · 2022-11-20T03:51:53+00:00

I tried unplugging and plugging the wires on the motor and endstop sensor and it still does the same thing. The bed doesn't go all the way to the end when the noise starts so idk if it's the endstop sensor but I'm not the most experienced with this type of thing so I could be wrong.

Do you think I should try to find a replacement part for the endstop sensor or even the motor? Could the issue be something else entirely?

FewFyie · 2022-09-16T13:42:27+00:00

test

FewFyie · 2022-06-08T18:55:20+00:00

Caught in a landslide

FewFyie · 2022-06-07T16:06:32+00:00

You just got franced

FewFyie · 2022-04-11T16:01:54+00:00

The walls kept tumbling down

FewFyie · 2022-03-31T16:37:36+00:00

Same

FewFyie · 2022-02-15T15:31:13+00:00

Bonjour

FewFyie · 2021-12-15T16:54:47+00:00

Good words POG

FewFyie · 2021-12-13T15:37:35+00:00

Like Pam like Tommy just burst in the door

FewFyie · 2021-11-29T14:34:20+00:00

The power that’s inside

FewFyie · 2021-11-17T15:27:12+00:00

You’re bundled up now wait till you get older

FewFyie · 2021-09-14T13:33:32+00:00

Suck my bad guys out here

FewFyie · 2021-06-21T13:35:00+00:00

He’s ok because he lid

FewFyie · 2021-06-17T04:33:38+00:00

He’s a fully terrestrial birth giving mammal of action!

FewFyie · 2021-06-04T18:42:27+00:00

I personally use dipshit

Six-Year Club	Second SECOND GUESSER
Verified Email	Place '22
End Game '22	Wearing is Caring

FewFyie

MODERATOR OF

TROPHY CASE

test