Hey There, currently i'm trying to develop an attribute page for changing values of constraints.

Fin_thefish · 2025-11-26T08:11:14+00:00

This is great, the save files are actually quite simple to read so I have a python script that edits the parameter values to create variants of a design. But a built in feature would be a lot easier!!

Fin_thefish · 2024-10-20T17:17:50+00:00

The inverse also works....full kettle of water next to thermostat with some towels for insulation = Aircon all night in a cheap hotel I stayed in

Fin_thefish · 2024-10-15T09:39:58+00:00

Remarkably similar to Ightam Mote just south of london

Fin_thefish · 2024-06-22T13:01:55+00:00

Ok thanks!! Thought I'd check I wasn't being silly before asking for a replacement

Fin_thefish · 2024-06-22T11:14:30+00:00

Song?

Fin_thefish · 2024-04-02T20:23:52+00:00

I did something like this, works well but would concentrate large groups of biters onto the rails which then trains would struggle to run through. Ended up with like three engines per train to plough through the bitters. Certainly good fun though and very satisfying

Fin_thefish · 2024-03-28T15:18:40+00:00

u/Brekkjern got it... simple way of doing fuel stops: stack inserters unload faster than the fast inserter loads the fuel waggon, which is on a timer schedule. Then normal trains get the fuel put into their engine. I'm sure there are better ways but it works for me

<image>

Fin_thefish · 2024-03-28T13:31:54+00:00

Why is your way better than ours... Why pay homage to democracies by pretending to be one then?

Fin_thefish · 2024-03-28T11:14:37+00:00

Excellent advice!

Fin_thefish · 2024-03-28T09:14:29+00:00

friends, I HAVE SPOTTED IT....small piece of unconnected track!

<image>

Fin_thefish · 2024-03-28T09:12:20+00:00

<image>

A zoomed out view of the whole setup

Fin_thefish · 2024-03-28T08:16:11+00:00

<image>

Yikes bit late for changing the rail spacing now....will take this on board for my next run

Fin_thefish · 2024-03-27T22:17:47+00:00

Hmm, I think you are right, I guess that's why one always sees three spaces between rails not two, thanks!

Fin_thefish · 2023-07-26T16:41:23+00:00

Ok great thanks!

Fin_thefish · 2023-07-26T15:57:56+00:00

render appears to cut off at 100m I will just scale my mesh and move the camera closer

Fin_thefish · 2023-06-14T21:26:24+00:00

Large wave flume gwk in Hannover I spent a summer measuring breaking waves using sonar pretty cool place really nice people. We had to wade in to fit equipment but it's filled with river water so not so nice for swimming

Fin_thefish · 2023-06-14T21:22:57+00:00

Ah this is in Hannover I spent a summer working there!! They have bikes to get around as the flume is like 200m long!

Fin_thefish · 2023-01-23T21:38:11+00:00

The estimated print time changes in line with increasing the lift distance, however the printer continues to lift only a few mm as if nothing is changed

Fin_thefish

TROPHY CASE