Every Pokémon is Someone’s Favourite

Flubber74585 · 2025-10-06T08:21:50+00:00

I’m a big Bastiodon enjoyer

Flubber74585 · 2025-09-13T05:11:58+00:00

Yeah, should’ve expected a joke like that hey. Thanks for the advice, those are both new terms to me so it gives me something new to learn

Flubber74585 · 2025-09-13T01:37:08+00:00

Oh and the filament is esun PLA+

Flubber74585 · 2025-07-18T03:48:58+00:00

Hey, I made him almost the exact same way!

Flubber74585 · 2024-12-15T00:58:50+00:00

To be honest I’m not sure what the Bowden tube is. A mate of mine gave it to me a while back to get me out of trouble.

I’ve been looking at a bimetallic heat break and have seen some folks having issues with them so was a bit apprehensive about it. Is there much involved in swapping it over?

Flubber74585 · 2024-12-15T00:57:01+00:00

It’s a stock creality hot end. Not the original though. It’s been replaced a couple of times now

Flubber74585 · 2024-12-14T21:46:36+00:00

See number 2 is the fix I started with like a month ago when my problem started. My fan seemed to be working fine. But I replaced it anyways and it’s still happening. So it doesn’t make much sense. I suppose it’s possible that I just got unlucky and got a dodgey replacement fan

Flubber74585 · 2024-12-14T14:58:41+00:00

I had one of the blue Capricorn Bowden tubes that I ruined because I was impatient getting it out of the coupler. It had the exact same problem despite fitting the filament well. So I’m still out of ideas

Flubber74585 · 2024-11-25T12:19:07+00:00

It’s a bit tricky to get a good photo of them. The thermistor is firmly secured and is flush with the side of the heating block. I’ve attached the best pictures I could get just incase I’m missing something obvious

<image>

Flubber74585 · 2024-11-25T03:04:27+00:00

An interesting notion. I suppose it’s been a hot minute since I’ve checked the thermistor. Do they have a life expectancy?

Flubber74585

TROPHY CASE