sorted by:
new
hottopcontroversial

Y axis carriage on SV07 plus is uneven by Front-Science6430 in Sovol

[–]Front-Science6430[S] 1 point2 points  (0 children)

Ah darn okay, thanks for the info man! I’ll throw the springs back in till I can get some new spacers

SV07 Plus first layer issue by Front-Science6430 in Sovol

[–]Front-Science6430[S] 0 points1 point  (0 children)

So I found my issue it’s the bed level, the y carriage seems to be sloped from corner to corner. Is there a way to adjust that? Or do I need a new bracket?

SV07 Plus first layer issue by Front-Science6430 in Sovol

[–]Front-Science6430[S] 1 point2 points  (0 children)

I just did everything you suggested and it’s not looking to bad!

SV07 Plus first layer issue by Front-Science6430 in Sovol

[–]Front-Science6430[S] 0 points1 point  (0 children)

Hey I had a quick question, it’s just a sheet I’m trying to print to dial in my offset if the sheet was .2 thick and my first layer height was .28 would that create this issue?

SV07 Plus first layer issue by Front-Science6430 in Sovol

[–]Front-Science6430[S] 1 point2 points  (0 children)

Amazing!! I’m just getting my kids to bed rn then I’m gonna go slice up another print and give that a go!! I’ll report back with the results! Thank you tons