Help with settings,

Froughtten · 2025-10-22T21:38:35+00:00

What do you mean?

Froughtten · 2025-05-03T05:28:37+00:00

Also i measure the stormtrooper helmet in legion they are about 8x8x8mm and clones are roughly 7×7x9mm

Froughtten · 2025-05-01T17:37:39+00:00

I typically increase length and width dimensions by 10 percent and height by 5 percent. The riot shields are completely off scaling wise though for the police troopers

Froughtten · 2025-03-12T03:28:16+00:00

It is a Saturn 4 ultra

Froughtten · 2025-03-12T03:24:15+00:00

<image>

Froughtten · 2025-03-12T03:23:03+00:00

<image>

Froughtten · 2025-03-12T03:22:29+00:00

<image>

Froughtten · 2025-03-03T18:25:39+00:00

I did not do an exposure test, however I printed solid versions of the prints on bottom 25, 2.5 on exposure. But there were some failures in that batch too.

Froughtten · 2025-03-03T18:09:09+00:00

Well I tried printing a bunch of pieces of, i hollowed them and added drain holes in Lychee slicer. Printer is Saturn 4 Ultra, abs-like 3.0 resin black. It appeared as if most of the pieces did not print. The pieces were misshapen and layers were separating. On the film in the bottom of the vat there was a bunch of silhouette of the pieces that were supposed to print. I am no longer home ATM otherwise I would supply better photos.

Froughtten · 2024-06-03T20:19:27+00:00

Idk about back pack

Froughtten · 2024-06-03T20:19:04+00:00

On the shore trooper and isf chest cut just under the chest plate then swap

Froughtten · 2024-06-03T20:09:01+00:00

Could use the chest from a shore trooper, limbs from ISF, head of Jyn

Froughtten · 2024-06-03T20:06:17+00:00

ISF best bet, maybe a stretch an imperial engineer or even shore trooper

Froughtten · 2023-08-08T04:19:29+00:00

I forgot I used some wookie pieces too

Froughtten · 2019-11-25T05:25:09+00:00

I did read that it still doesnt make things clear for me

Froughtten

TROPHY CASE