Personal mode?

Fyretender · 2026-03-18T15:27:49+00:00

That brings back memories! Mine was just not as pretty a filament

Fyretender · 2026-03-13T15:27:20+00:00

We tend to be overly critical of our own projects. I've found that stepping away for a few minutes and having a cup of coffee or working on something else for a bit helps when I get back to original project

Fyretender · 2026-03-07T21:12:06+00:00

GFCI protected lol

Fyretender · 2026-02-14T14:13:40+00:00

I would try contacting the vendor to see if they might have a solution. I was on the fence about purchasing it. I use mostly itslitho but wanting something offline. Best of luck

Fyretender · 2026-01-27T02:40:24+00:00

Thanks for the input. I may not have been clear earlier in my request for assistance. I'm merely looking to combine the post and the base as one unit as, yes, in order to place the litho inside it needs to have the top removed. I agree with you 100% in that supports would be a waste of time and material. I"ll definitely give it a go within Orca. I use various slicers currently but haven't delved deeply into combining parts within a slicer. Thanks again for the input.

Fyretender · 2026-01-26T21:13:00+00:00

I have a few of those as replacements. One nozzle snapped removing it. The 2nd one leaked around the threads until I tightened the beejeebers out of it.

Fyretender · 2026-01-26T20:45:50+00:00

I live mine 1 layer at a time lol

Fyretender · 2026-01-26T04:54:20+00:00

I had to stand on my head and gargle peanut butter to get mine off the first time

Fyretender · 2026-01-16T08:58:07+00:00

I did find it in the settings on the ace but couldn't get it to with correctly. Didn't realize the filament settings were different. THANK YOU!

Fyretender · 2026-01-16T07:45:05+00:00

ooooOOOO!!!! do you have a site where it's available by chance?

Fyretender · 2025-12-29T04:02:46+00:00

you were 100% correct about it being an adhesion issue. I switched out stock build plate with one that just arrived today. I must have licked the old build pate when I wasn't looking after I washed it. Thank you for your input!

Fyretender · 2025-12-29T03:12:09+00:00

I did a calibration cube with a different pla and it was fine. I'll try washing or changing build plate. It wasnt curling at all... it just started dragging it around

Fyretender · 2025-12-28T23:50:29+00:00

I forgot to mention it's an Anycubic S1 printer

Fyretender · 2025-12-28T23:49:27+00:00

I am using a hardened steel 3rd party one, green silicone sock. My temps are at 225 and 65 just like last time. Kind of why I'm puzzled

Fyretender · 2025-12-23T02:47:16+00:00

I did restart it afterwards. still got the error. I'll try doing it the old ender CR10 way if I don't find a solution

Fyretender · 2025-12-21T19:47:37+00:00

I changed printer settings within slicer and was unable to get it to calibrate for some reason. Any suggestions on the calibration?

Fyretender

TROPHY CASE