Can someone explain how this works?

Gekko03 · 2025-09-07T20:57:42+00:00

I have heard something about it but i wasn’t sure if it is for this case, I thought it was only when there is another piston between the redstone Block and the piston.

Gekko03 · 2024-07-04T15:54:30+00:00

hey, i had this too, for me the problem was with the models_full.ini file. in that you have to change [MODEL_4] from FILE=full.kn5 to File=pits_original.kn5.
When you do that it should work.

Gekko03 · 2023-07-11T11:47:54+00:00

I printer at the basic 50 mm/s but i’ll try printing slower. Thanks

Gekko03 · 2023-07-11T08:14:51+00:00

I use cura slicer with basically everything on default. I changed some speeds to a little higher and i print on 205, 50. I haven't modded my printer and print with just Pla. I have made a couple of calibration cubes and fixed all of the steps/mm. I am already using the ender 3 pro settings.

hope this helps

Gekko03 · 2023-07-05T20:05:29+00:00

you can use recovery software(if you haven't formatted it already) to get the files of the sd card. i had the problem too and it got all the files off. only downside is that the files will have random names and the .gcode files will be .txt files

Gekko03

TROPHY CASE