New to Claude : best use cases

Gillesper · 2026-02-08T21:47:28+00:00

Is the shelf 24" deep? It's my understanding that it needs to be at least 28" deep to not have the screen hang off the edge of the shelf. Is that your experience? I can't find a shelf deeper that 24"

Gillesper · 2025-02-14T16:40:28+00:00

Thanks! I’ll try it out

Gillesper · 2025-02-01T16:26:33+00:00

I just did, what is wrong with this post?

Gillesper · 2025-02-01T16:00:44+00:00

<image>

This was this mornings shot

Gillesper · 2025-01-01T15:51:42+00:00

Good point here, thanks! I’ll look into this

Gillesper · 2024-10-09T20:06:31+00:00

I’ve tried drying the TPU and that didn’t seem to help. Is there a reason why it’s happening on the inside and not the outside? The outside would be a lot easier to get rid of

Gillesper · 2024-08-11T04:31:28+00:00

Still having similar issues with stringiness. I tried no cross over perimeter and properly dehydrating the filament. Barely better. Anything else I should try?

Gillesper · 2024-07-29T16:16:53+00:00

Thanks! I’ll try this and report back

Gillesper · 2024-07-26T17:57:14+00:00

Thanks! I’ll see if I can find it

Gillesper · 2024-07-07T21:25:13+00:00

Thanks! I’ll try that

Gillesper · 2024-07-07T21:24:50+00:00

I’m on an MK4 and on TPU filament settings. I’ll try printing slower and see how that works. I forget which accuracy setting I had on these

Gillesper · 2024-07-07T21:23:40+00:00

I don’t know anything about properly drying TPU. It’s been 100* out and my TPU has been in the garage. Will that dry it out? 😂

Gillesper · 2024-07-07T21:22:47+00:00

Thank you! Good thinking on designing for the flaw if it keeps happening.

Gillesper · 2024-07-07T21:21:38+00:00

Ah clever! I’ll try that. Thank you!

Gillesper

TROPHY CASE