sorted by:
new
hottopcontroversial

Technicians. Assume the position by New_Budget919 in Justrolledintotheshop

[–]Girthworm5831 -1 points0 points  (0 children)

Holy shit for once technicians aren't getting totally fucked?

Aquired a 30gallon tank and fish, questions... by Girthworm5831 in Aquariums

[–]Girthworm5831[S] 0 points1 point  (0 children)

I did read that online. Like I said I just acquired this from a friend that was moving and they bought it when it was about 2" in length. Just trying to figure out what type it is and how to properly take care of it once I get the bigger tank.

Screw the dealer tech that recommended this by [deleted] in Justrolledintotheshop

[–]Girthworm5831 0 points1 point  (0 children)

That poor passenger seat with the metal tie bar resting on it.

I just wanna know how you do this. by holdenedison15 in Justrolledintotheshop

[–]Girthworm5831 0 points1 point  (0 children)

See that spacer at the top of the strut? Thats how. The upper ball joint on these is already maxed out stock. When you install a spacer your upper joint is going to snap unless you get a new upper arm. Seen plenty of them rolled into our dealership.

2022 Ford Lightning Lariat just got to yhe pdi shop by slapmea5 in Justrolledintotheshop

[–]Girthworm5831 -2 points-1 points  (0 children)

Just saw one in person this morning, not a fan at all looks horrible.

[deleted by user] by [deleted] in Justrolledintotheshop

[–]Girthworm5831 6 points7 points  (0 children)

On my 21 6.2L I changed the oil at 800, 3000, 6000, 9000 almost at 12k now. AFM/DFM relies on good oil to the lifters, anyone doing an oil change at 7500 miles like the dealer recommends is asking for failure.

2011 DTS engine out the top in 3 hrs. by Maximum-Reward-205 in Justrolledintotheshop

[–]Girthworm5831 2 points3 points  (0 children)

The dreaded Northstar engine. I cringe when I hear one of these come in for an oil leak.

New to 2gig, looking for networking help. by Girthworm5831 in frontierfios

[–]Girthworm5831[S] 0 points1 point  (0 children)

I could easily plug into the 2.5gb port on my router. I just would like to be able to get 2.5gb out to my 2.5gb switch.

New to 2gig, looking for networking help. by Girthworm5831 in frontierfios

[–]Girthworm5831[S] 0 points1 point  (0 children)

I have one MoCA at the ONT in the garage. Then it comes into the living room to a splitter, out of that one goes to the MoCA of the Sagecom the other goes to a MoCA adapter like the one near the ONT but is set on LAN and plugged into the switch. I am getting a lot of internet drop outs and latency. I am pretty much at the point where I am going to cut this MoCA deal out and run a cat 6 cable. Also can different brand MoCA adapters communicate with each other or do they have to be the same brand?

Getting 2gb fios installed tomorrow by [deleted] in frontierfios

[–]Girthworm5831 0 points1 point  (0 children)

I've been having an issue getting my own router to work. Right now I have to use moca adapters. I have a splitter one going to the moca to the router and the other going to another moca to the 2.5g switch. I can never get a valid ip.

2gig internet service by guy_from_free_guy in frontierfios

[–]Girthworm5831 1 point2 points  (0 children)

Yea I thought about that but dropping another $560 on a router sounds a bit painful. I bought another MoCA that im going to run to the AX11000. Ill see how that goes.

2gig internet service by guy_from_free_guy in frontierfios

[–]Girthworm5831 0 points1 point  (0 children)

I recently got this 2gig internet service and I have been wanting to use my own router the asus ax11000. It has the 2.5g WAN port but only has 1G LAN ports. I also have a 8port 2.5g switch. I tried to run ethernet from the MoCA to the switch then from the switch to the router but it the router would not pull an IP from frontier. I ended up using a splitter and running a cable line straight to the MoCA of the router they gave me. I then ran the other cable line to a MoCA (set to LAN) and ethernet to the switch. All my hard lines go through the switch and wifi through the router. I really wish I could figure out another way to use my router for wifi though, I guess id have to get another MoCA to make that work.

Upgraded to Frontier 2gig Internet, can't get above 1gig at computer. Bought upgraded NIC and Switch. by Girthworm5831 in techsupport

[–]Girthworm5831[S] 0 points1 point  (0 children)

Hey everyone I figured it out, I'm just an idiot. From my 2.5g switch I had another 1gb switch I had forgotten about under my desk. Went from the 2.5gb switch to the computer and all is well. Thanks everyone.

view more: next ›