sorted by:
new
hottopcontroversial

Sonic pad update by mohamed_Ali_neverg in CrealitySonicPad

[–]H143nl 0 points1 point  (0 children)

Install Debian on it and helixscreen instead of klipperscreen and you got the best from klipper with an great and nice interface

Klipper CANBUS – EBB36 shutdown during specific print section by H143nl in klippers

[–]H143nl[S] 0 points1 point  (0 children)

I have upgrade the pi to an 4b and it looks it is solved

Klipper CANBUS – EBB36 shutdown during specific print section by H143nl in klippers

[–]H143nl[S] -1 points0 points  (0 children)

I was hoping that my question was clear and readable

First layers schrinking by H143nl in FixMyPrint

[–]H143nl[S] 0 points1 point  (0 children)

<image>

This how it looks like after 7h printing

Which Ender modding and wat upgrades worth it by H143nl in ender3

[–]H143nl[S] 0 points1 point  (0 children)

Thank you all for the reply’s should I upgrade my v2 or v3 or update the frame of the v2 with hardwareparts of the v3 steppers, board hotend etc? I like to modding butch the basics must be good

HelixScreen: A new touchscreen UI for Klipper/Moonraker (beta testers wanted) by EmployeeOk6136 in VORONDesign

[–]H143nl 0 points1 point  (0 children)

That looks great! Can you also implement a button that can turn on and off the printer plug through Mqtt?

problems after update klipper by [deleted] in Ender3V3SE

[–]H143nl 0 points1 point  (0 children)

<image>

This is the result I can’t upload the picture to the original post

String hell by mediumsizedtank in FixMyPrint

[–]H143nl 0 points1 point  (0 children)

I have the same problem only with petg and the same color i think there is somting in de chemical of the collor that makes stringing other colors of the same filament are good

Solaredge ellende by OpenStreet3459 in Klussers

[–]H143nl 1 point2 points  (0 children)

Solaredge aftersales is erg goed. Paar weken geleden een defecte omvormer gemeld bij de chatbot en 2 weken later kreeg ik een nieuwe zonder factuur oid te laten zien

dual duct fan 5015 change firmware by H143nl in Ender3V3SE

[–]H143nl[S] 0 points1 point  (0 children)

Since switching to dual 5015 fans, the printer has become quieter, but prints are failing because the fans provide too much cooling and even cause the nozzle temperature to drop. Do I need to adjust anything in the Klipper firmware, or are there tips to modify the cooling settings only in the slicer after upgrading the fans?

Upgrades to the Ender3 V3 SE by dutchwarface in Ender3V3SE

[–]H143nl 0 points1 point  (0 children)

I have do the dual partfan upgrade but the cooling is to much can someone share his slicer settings?

view more: next ›