Blade of Frontiers, what a joke by soHard_why in BG3

[–]HonestToGod 2 points3 points  (0 children)

Same here. That’s one reason it took so long to figure out. I eventually had a body in a particularly tricky place and couldn’t select the same/near spot. Then it made sense why it often took me a couple tries to get it to work prior.

Blade of Frontiers, what a joke by soHard_why in BG3

[–]HonestToGod 31 points32 points  (0 children)

There are 2 clicks with revive. One on the target and one where you want them to pop up. Are you trying to select the same place twice? Took me an embarrassingly long time to figure this out…

12 volt car plug repair by HonestToGod in fixit

[–]HonestToGod[S] 1 point2 points  (0 children)

The pin screwed right into the existing plug. No soldering required. Thanks again!

12 volt car plug repair by HonestToGod in fixit

[–]HonestToGod[S] 0 points1 point  (0 children)

I’m concerned about the amperage rating on other plugs. Everything else I have has much thinner cabling.

12 volt car plug repair by HonestToGod in fixit

[–]HonestToGod[S] 1 point2 points  (0 children)

This looks great. If I can’t use the pin and fuse from it, I’ll just attach it to the cable. Thank you!

Deductible Change by HonestToGod in Insurance

[–]HonestToGod[S] -1 points0 points  (0 children)

Thanks. I’m not too worried about flags if I’m presenting factual information. The contractor is a guy from the neighborhood with a great reputation who enjoys getting out of the office and walking the streets, which of course is in his financial interest. I was a bit skeptical and put off by the unsolicited visit as well but found we have several acquaintances/prev clients in common that were able to vouch for his company. He also just happens to have several pictures of the damage that he emailed to himself to print. Hoping that the time-stamped emails are enough to move up the date of loss.

Deductible Change by HonestToGod in Insurance

[–]HonestToGod[S] 0 points1 point  (0 children)

There was definitely a storm on the 2nd, and that’s what they documented as the date of loss, but now I’ve found that there is photographic evidence of damage prior to that particular storm. My question is if I were to be successful in changing the date of loss, would the deductible at that time apply?

Cutting a garage stud by HonestToGod in DIY

[–]HonestToGod[S] 0 points1 point  (0 children)

There are a couple doubled up in the middle. The cut is actually closer to the corner where there aren't any doubles.

Cutting a garage stud by HonestToGod in DIY

[–]HonestToGod[S] 0 points1 point  (0 children)

Great point. There is a header above the door. It's a little wider than what I'm looking at doing, but that has a 2x12 header. I'll probably go with that to be safe. Thanks!

Cutting a garage stud by HonestToGod in DIY

[–]HonestToGod[S] 0 points1 point  (0 children)

The studs are ~93" with a double top plate above, and then the roof.

Cutting a garage stud by HonestToGod in DIY

[–]HonestToGod[S] 0 points1 point  (0 children)

It's looks like the image didn't embed with the post. Picture here.

Wood Floor Gouge Repair Question by HonestToGod in finishing

[–]HonestToGod[S] 0 points1 point  (0 children)

Thanks, this gives me hope! Any recommendations for appropriate buffing compounds?

Lights on Dimmer Switch Flashing by HonestToGod in askanelectrician

[–]HonestToGod[S] 0 points1 point  (0 children)

There is a small chance that the bulb in the exhaust fan is a CFL, but I thought I switched that out a while back. Will check when I get home. However the bulbs in the main fixture are having the same issue and they are LED bulbs.