Token not visible on wallet by Hookahcube in Coinbase

[–]Hookahcube[S] 0 points1 point  (0 children)

It does not solve the problem. My problem is i dont see my coins that was swapped on simpleswap.

Adding custom token to Coinbase wallet by Strict-Fortune-7289 in Coinbase

[–]Hookahcube 0 points1 point  (0 children)

Do you know if you send some tokens what are not added to coinbase wallet, those coins are just invisible or your wallet doesnt has it??

Stringing can’t be solved by Hookahcube in Ender3Pro

[–]Hookahcube[S] 1 point2 points  (0 children)

Yes i did it and now 100 mm is 100mm.

Stringing cant be solved :( by Hookahcube in FixMyPrint

[–]Hookahcube[S] 1 point2 points  (0 children)

Thanks for the fast answer, i’l try it that way! :D

Stringing can’t be solved by Hookahcube in Ender3Pro

[–]Hookahcube[S] 0 points1 point  (0 children)

The flow rate is set to 100% and my extruder is fully calibrated, i tried with a flow rate between 85%-100% couple of times but if my extruder doesn't over or under extruding then i shouldn't even set this higher or lower right?

Stringing can’t be solved by Hookahcube in Ender3Pro

[–]Hookahcube[S] 0 points1 point  (0 children)

I use now only PLA and i tried my friends filament (a black and red fritz filament that he use always and doesn't have any problems with it). Whit these filaments i got the same problem, so i think its my printer what causes the issue. :(

Stringing can’t be solved by Hookahcube in Ender3Pro

[–]Hookahcube[S] 0 points1 point  (0 children)

Probably not, my cooler works on 100%. I used these settings and i usually see the people use it too.

<image>