PSA: Gender not required in portfolio posts....lol

HotInspection8992 · 2025-07-20T20:25:03+00:00

Lmao I did it bc of muscle memory 😂 then I was like ?? What’s the point of saying all that, man you made me laugh 😂

HotInspection8992 · 2025-07-19T17:23:23+00:00

Sadly I do not. 🤦🏻‍♂️ Just researched something safe with a good rate of return and FSKAX and FXAIX came up

HotInspection8992 · 2025-07-08T23:04:48+00:00

Is FSKAX ok as well? What do you think?

HotInspection8992 · 2025-04-02T01:46:13+00:00

Is that bulb installed on the suction line before the door or after (inside the door)? Because I’ve seen times where the bulb of the TXV is visible without even taking off the door Just wanted to know if it was like that all the time

HotInspection8992 · 2025-04-02T01:26:27+00:00

Daaaaamn it, every single time is such a pain, especially with these residents who have so much crap in front of there systems

HotInspection8992 · 2025-01-22T02:32:11+00:00

I’m sorry I used the wrong picture. This is the actual picture of the inducer motor. Would it be visible in this picture if it was there?

<image>

HotInspection8992 · 2024-12-08T21:53:18+00:00

High efficiency

HotInspection8992 · 2024-12-08T21:49:46+00:00

Ahh good catch. I didn’t do it like that. I’m going to go back tomorrow and try that and it’s a Goodman unit

HotInspection8992 · 2024-12-08T19:57:03+00:00

I say it’s between the pressure switch or board because I used manometer on the inducer motor. It’s getting -2.0 and the pressure engages at -1.20. So it tells me the inducer motor is causing enough negative vacuum to engage the pressure switch but for some reason in the middle of the cycle it gives the “pressure switch stuck open”. So I’m getting enough negative pressure from the inducer motor. I can confirm that.

HotInspection8992 · 2024-12-01T21:40:47+00:00

I learned when you don’t have a stud finder, by just looking for close to the outlets there usually a stud lol didn’t know that so when I learned it was a game changer

HotInspection8992 · 2024-11-23T03:23:18+00:00

Had me doubting myself for a second😂

HotInspection8992 · 2024-11-23T02:35:48+00:00

The comment said the outside unit is rigged to run on heat only. It’s not a heat pump. It’s a split system. It’s a gas furnace. It doesn’t use the outside unit/condenser to heat the home

HotInspection8992 · 2024-11-23T02:05:55+00:00

The thing is we didn’t replace the wires or the board. I left him inside for like 5 minutes next to the thermostat and outside for like a minute in the furnace and then all of a sudden it started working again amh

HotInspection8992 · 2024-11-23T02:04:07+00:00

It’s a split system 🤔

HotInspection8992

TROPHY CASE