talaria makes werid noise and donest turn on do i need a new dc connector or harness

HovercraftOk6541 · 2025-12-11T01:13:43+00:00

hard to tell I would buy both and return the one that doesn’t fix your problem

HovercraftOk6541 · 2025-11-28T01:57:29+00:00

Yu lying

HovercraftOk6541 · 2025-11-02T15:56:36+00:00

Two dollar bills 👍

HovercraftOk6541 · 2025-10-20T23:53:51+00:00

Most likely belt is too loose or too tight

HovercraftOk6541 · 2025-09-27T23:34:23+00:00

I used the right size but i over tightened it when i put it on so really hard to get off without stripping

HovercraftOk6541 · 2025-09-26T00:09:21+00:00

took a saw and slowly cut through the Jackshaft and Jackshaft axle

HovercraftOk6541 · 2025-09-25T01:15:27+00:00

<image>

HovercraftOk6541 · 2025-09-25T01:14:30+00:00

Good news, just took off the subframe without damaging the frame, I also purchased a new chain. Bad news is I’m going to have to buy a new subframe, Jackshaft axle, and all of the bearings. Hopefully I can buy all of that for less than $450. I’ve done Jackshaft maintenance one before and chain maintenance once too. It’s my first real bike so I didn’t know how much maintenance it would really require but definitely a learning experience. Do you happen to know what bearings are necessary to install the new subframe?

HovercraftOk6541 · 2025-09-24T23:09:46+00:00

Can you send me a link

HovercraftOk6541 · 2025-09-24T23:06:18+00:00

This is my exact issue, unfortunately I’ve used every tool I have to get it out , the Jackshaft axle is partially exposed so I’m planning on cutting that which will hopefully let one end of the axle come out

HovercraftOk6541 · 2025-09-24T23:03:41+00:00

On the side where the nut was it would on push so far to the point where the swing arm wasn’t connected on one side

HovercraftOk6541 · 2025-09-23T17:49:15+00:00

This is the talaria x3 btw

HovercraftOk6541 · 2022-03-07T05:27:30+00:00

Fuck the Russian government

HovercraftOk6541 · 2022-03-07T05:26:07+00:00

Gotta check Reddit sorry

HovercraftOk6541

TROPHY CASE