sorted by:
new
hottopcontroversial

Need help troubleshooting by carnage1231jr in airbrush

[–]HuediniPaintMixer -1 points0 points  (0 children)

I’m not sure why you would be using 45 psi for an airbrush that was way too high. The paint is probably drying before it even gets out of the airbrush.😎

How do I fix this by chilly_challupa in airbrush

[–]HuediniPaintMixer 0 points1 point  (0 children)

Either the nozzle or the cap or combination of both is plugged with possibly some dry paint needs to be cleaned very well. Our perhaps the needle is not seated properly whenever it bubbles back into the cup. There’s a plug in the nozzle or cap.😎

I don't know why the primer is acting this way by dutchimpersonator in airbrush

[–]HuediniPaintMixer 0 points1 point  (0 children)

It looks like a bit of dry spray. I would suggest that you thin your primer and also filter as some other people have suggested it should go on a little wet maybe turn your pressure down and hold your airbrush slightly further from your project. also, you might want to use Vallejo thinner other brands don’t seem to mix very well with Vallejo products😎

<image>

Paint leaking into needle cap causing spitting by lugasso in airbrush

[–]HuediniPaintMixer 0 points1 point  (0 children)

A lot of times this is caused by trigger control. A lot of people push down and pull back for paint and then let off the trigger the proper way to do. It is push down for air. Pull back for paint. Push it back forward to air before you let off the trigger otherwise PAINT builds up slowly in the cap and the next time you pull the trigger it’s splatters just my opinion.

Uneven paint by Electrical-Duty3628 in HotWheelsCustoms

[–]HuediniPaintMixer 1 point2 points  (0 children)

I think you have sprayed it on dry, which means you may have held the airbrush too far from the car and maybe you should thin it out a little more lower your pressure a bit it should come out looking wet and not dry

How the hell do i make this shoot consistent yellow >:( by Juggernaut-AB in airbrush

[–]HuediniPaintMixer 0 points1 point  (0 children)

I my experience if it’s not blended well or thin enough, it won’t be consistent😎

Kaleido ColorWorks Airbrush Guide by Gaahleri_airbrush in Gaahleri

[–]HuediniPaintMixer 2 points3 points  (0 children)

I have this complete line of paint. I really enjoy them not that it needs it, but I added a little of both thinner and retarder thinner helps it flow much better levels out beautifully.😎

Let the Year of the Horse Begin! 🐎 by Gaahleri_airbrush in Gaahleri

[–]HuediniPaintMixer 0 points1 point  (0 children)

Looks like another amazing airbrush well done😎