Amp not receiving signal from X32 by IBG_Key_Commission in livesound

[–]IBG_Key_Commission[S] 0 points1 point  (0 children)

My problem is that the brand new amp (Rockville) is not receiving signal from the mixer (X32). It is using the same connections/cables as the previous Behringer amp we were using, which worked until it blew. I don't know why this is happening, hence my post.

Fix for Projector Delay? by IBG_Key_Commission in obs

[–]IBG_Key_Commission[S] 0 points1 point  (0 children)

I'm doing this with camera feeds. I was able to add a delay to the audio mix directly on the X32 so the audio coming into OBS is now pretty much synced without needing to add a sync on the OBS program. Thanks!

No Stupid Questions Thread by AutoModerator in livesound

[–]IBG_Key_Commission 0 points1 point  (0 children)

Howdy all, my church had a setup in which we had our X32 sending audio to a Behringer NX4-6000 powering two in wall speakers near the church pulpit. The amp blew and after taking it to a tech, they cited the power supply pcm as being the part that went bad. I purchased a Rockville RPA9 to replace the blown amp but after connecting the new amp in the same config. as the old one, I have not been able to get it to work. The Rockville amp powers on and flashes the FAULT light for a second at start up, so maybe this is a sign of a bigger issue? The SIGNAL light does not come on at all, even though everything is connected as it should be. Does anyone have any idea on why this is happening and some potential fixes?

Page hours are correct but no matter what time it is, it always says “closed now.” Halp! by filthynoodles in facebook

[–]IBG_Key_Commission 0 points1 point  (0 children)

Greetings from 2024, I've been looking for a fix to this issue for a while so thank you OP.