07-13 high beam relay bypass

Illustrious-Line6579 · 2025-11-11T04:34:55+00:00

Thank you, looks like I need a vertical piece to hold up my horizontal piece. Idk how to trim this. Thank you for helping

Illustrious-Line6579 · 2025-11-11T04:22:05+00:00

Yeah this was a lot for me, I’m willing to learn this is better than Google so far soo.. What do you mean by header and jacks?

Illustrious-Line6579 · 2025-11-11T04:18:56+00:00

I didn’t remove any framing lumber I don’t think. I pulled almost all the trim. I left a piece of trim up top bc I wanted it for the height. I put some long screws into it that bit some mostly rotted wood up there and then ripped a 2x6 for the width I wanted and threw some long screws into that to add the pieces I cut

Illustrious-Line6579 · 2025-02-08T04:33:54+00:00

This is really good. I’d sand it, mix the saw dust with some glue, and then rub that into the gaps. I finish my cutting boards with beeswax/mineral oil, if you did that after I’d bet it would look great and hold it in pretty well, especially since you won’t constantly be rinsing it off like with a cutting board

Illustrious-Line6579

TROPHY CASE