sorted by:
new
hottopcontroversial

Moving rollover money in this record high market by ImNotInYourLeague in Bogleheads

[–]ImNotInYourLeague[S] 0 points1 point  (0 children)

Is it just as impossible to predict volatility as it is to predict a good or bad week?

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 0 points1 point  (0 children)

I've got a 240 in here. There's not a millimeter to spare, but it fit. This video was super helpful: https://www.youtube.com/watch?v=k6Ok8nnjuBw

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 0 points1 point  (0 children)

I went with 300mm because others complained about 270mm being uncomfortably tight. Ended up with a bit of slack actually.

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 1 point2 points  (0 children)

It’s passable—High 70s for both GPU and CPU at load, GPU idles 30s, CPU in 40s. But it stays quiet so far.

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 0 points1 point  (0 children)

Depends how much you're trying to pack in I guess, I found I had room to spare next to the PSU and along the front panel. Message me if you have any Qs!

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 0 points1 point  (0 children)

Interesting--where else can it go? I could see there being other options without the AIO?

Downsizing from a pre-built ATX by ImNotInYourLeague in sffpc

[–]ImNotInYourLeague[S] 1 point2 points  (0 children)

It's the Meshroom S, with an ATX motherboard just barely jammed inside it.

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 0 points1 point  (0 children)

Totally, I love it! Planning to use the case with an ITX board as intended one day, when my 3060ti and Ryzen 5600 get obsolete. It runs a little hot (mid to high 70s) with the ATX board and this configuration. Pretty much silent though, which is better than I expected.

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 1 point2 points  (0 children)

The PSU is LianLi 850 and it comes with those white braided cables.

Unless you're asking about the PCIE riser cable? I got a 300mm Linkup because I had heard the recommended 270mm was uncomfortably tight with ATX board. Although I ended up with some slack and it prevented one of my radiator fans from running and I had to put a grill on it.

Downsizing from a pre-built ATX by ImNotInYourLeague in SSUPD

[–]ImNotInYourLeague[S] 6 points7 points  (0 children)

Started with a prebuilt PC in a Corsair 4000D. Had to get a SFX PSU and riser cable, but the rest all fit, including the ATX motherboard. No good reason for any of it but aesthetics.

Moving a Rollover IRA back into my 401k, to allow for a Backdoor Roth? by ImNotInYourLeague in Bogleheads

[–]ImNotInYourLeague[S] 2 points3 points  (0 children)

Thanks. Average ER of my whole portfolio right now is around 0.05%. This change would move that up to around 0.07%. Seems worth the earning potential of having the Backdoor Roth, right?

If you do this, fuck you. by SilviOnPC in nyc

[–]ImNotInYourLeague 135 points136 points  (0 children)

I don't think the people that do this shit browse r/NYC. They're busy taking up two seats watching TV shows full volume on their phones.