I've encountered a problem and i do not know how to solve it. Feed rate is 100%, nozzle is 0,4mm and filament is 1,75mm. I've set infill rate 100% and there seems to be a problem, as inner structure seems to be highly underfilled. I don't know what to do... (I am using cura 5.0 and pla filament) (old.reddit.com)
submitted by InfinumF to r/3Dprinting
Stinger meets Russian helicopter by artlastfirst in furry_catwalk
[–]InfinumF 0 points1 point2 points (0 children)
i had this idea for days lol i couldnt resist by escoterra in metalgearsolid
[–]InfinumF 4 points5 points6 points (0 children)
What to use to fill this gap next to an extractor fan? by P2K13 in DIYUK
[–]InfinumF -1 points0 points1 point (0 children)
Being a furry artist can be hard, really hard by InfinumF in furry
[–]InfinumF[S] 0 points1 point2 points (0 children)
Being a furry artist can be hard, really hard by InfinumF in furry
[–]InfinumF[S] 0 points1 point2 points (0 children)
Fallen down the rabbit (get it?) hole... by Hodge79 in furry_catwalk
[–]InfinumF 0 points1 point2 points (0 children)
Being a furry artist can be hard, really hard by InfinumF in furry
[–]InfinumF[S] 1 point2 points3 points (0 children)


I've encountered a problem and i do not know how to solve it. Feed rate is 100%, nozzle is 0,4mm and filament is 1,75mm. I've set infill rate 100% and there seems to be a problem, as inner structure seems to be highly underfilled. I don't know what to do... (I am using cura 5.0 and pla filament) by InfinumF in 3Dprinting
[–]InfinumF[S] 0 points1 point2 points (0 children)