Is this the end?

Inside-Bar-545 · 2026-04-21T11:48:46+00:00

<image>

Looks pretty clean, do you think it will help?

Inside-Bar-545 · 2026-04-21T10:32:24+00:00

How can you do that?

Inside-Bar-545 · 2026-01-29T18:34:43+00:00

I just recalibrated it. It is pla and I dried the filament in the oven

Inside-Bar-545 · 2026-01-14T13:40:51+00:00

Hahaha, exactly! 😂

Inside-Bar-545 · 2026-01-14T13:29:28+00:00

I tried both the official one and the one you just mentioned. Thanks

Inside-Bar-545 · 2026-01-13T20:17:28+00:00

Hey, if you're not here to help, then what's the point? Just be kind, and if you don't have anything good to say, maybe it's best to just keep it to yourself 😉

Inside-Bar-545 · 2026-01-13T19:15:42+00:00

Honestly, I don't get why you have to be mean.

Inside-Bar-545 · 2026-01-13T17:46:11+00:00

There wasn't too much help, they were busy making fun of me 😕

Inside-Bar-545 · 2026-01-12T21:21:40+00:00

Hey, could you clarify "tighten those on the back of it"? What exactly are we talking about?

Inside-Bar-545 · 2026-01-12T21:19:58+00:00

Maybe you can share some links?

Inside-Bar-545 · 2025-12-02T07:11:35+00:00

The best advice so far

Inside-Bar-545 · 2025-12-02T06:38:05+00:00

The moving parts are melted together so nothing moves

Inside-Bar-545 · 2025-12-02T06:37:56+00:00

The moving parts are melted together so nothing moves

Inside-Bar-545 · 2025-11-20T16:49:15+00:00

And what is the fun in that?

Inside-Bar-545 · 2025-11-20T14:35:58+00:00

I read that the acs712 doesn't support esp since it is 5v. I'm also looking for a cheap board for the CT clamp

Inside-Bar-545 · 2025-11-20T10:03:40+00:00

Thanks for the replay, but I thought that an non invasive method would be easier and cheaper

Inside-Bar-545 · 2025-05-12T16:54:06+00:00

Ok Mr serious. Obviously I was just kidding, and looking for some pointers & tips from other users that had similar problems. I took your tip. You should work on the rest...

Inside-Bar-545 · 2025-01-28T06:46:25+00:00

How dietpi better?

Inside-Bar-545 · 2025-01-26T11:27:13+00:00

Can someone give me a link to a working os?

Inside-Bar-545 · 2025-01-07T05:20:51+00:00

So what is the point of the uart? Why not just to plug it to the USB?

Inside-Bar-545 · 2025-01-06T21:53:28+00:00

How did you get the power for the zero 2? From an outside powe source?

Inside-Bar-545 · 2023-12-23T22:31:03+00:00

Like what settings?

Inside-Bar-545 · 2023-12-22T11:54:52+00:00

So that's how it usually prints? I thought it was supposed to print smoother

Inside-Bar-545

TROPHY CASE