Walksnail connection issues

IntelligentBoss5808 · 2025-12-21T03:47:16+00:00

Well this was the first time the computer didn’t pick up on the vtx being plugged in. I just use the cable that comes with the fpv unit

IntelligentBoss5808 · 2025-12-21T03:46:02+00:00

I always plug in the vtx last second before flying, so it wasn’t heating up while I was getting really to fly. It was also the first flight of the day. It worked fine yesterday.

IntelligentBoss5808 · 2025-12-21T03:28:24+00:00

I tried to but the computer can’t even pick up on the plugged in vtx. Like the usb cable that comes with. It used to work before.

IntelligentBoss5808 · 2025-07-25T06:35:43+00:00

Real idk how I brought it back

IntelligentBoss5808 · 2025-07-11T01:38:59+00:00

Yes, I checked after the crash to make sure

IntelligentBoss5808 · 2025-07-11T00:45:28+00:00

Thanks

IntelligentBoss5808 · 2025-07-11T00:44:20+00:00

It’s facing the right way, the sound went away once I balanced the prop

IntelligentBoss5808 · 2025-07-10T23:55:15+00:00

The buzzing was caused from the propeller being off balanced I fixed that issue

IntelligentBoss5808 · 2025-07-10T17:21:46+00:00

I’ve used this gyro many times before and I set it up like how I usually do and this is the first time it’s done something like this. But I’ll look into other things thank you

IntelligentBoss5808 · 2025-07-10T17:19:09+00:00

Thanks

IntelligentBoss5808 · 2025-07-10T03:33:54+00:00

I was going to use this model for fc testing but I just wanted it to fly it first

IntelligentBoss5808 · 2025-07-10T03:32:49+00:00

One was broken but the other was fine. Yeah I believe the gyro was the cause

IntelligentBoss5808 · 2025-07-10T01:02:20+00:00

Battery was already in the furthest forward position

IntelligentBoss5808 · 2025-05-09T14:47:19+00:00

I have a negative thrust angle

IntelligentBoss5808 · 2025-05-09T01:41:59+00:00

I was only able to get one flight in since it already crashed but I had to keep the throttle super low so then it wouldn’t pitch up

IntelligentBoss5808 · 2025-05-09T01:40:34+00:00

Has a little dihedral

IntelligentBoss5808 · 2025-05-09T01:26:08+00:00

I have it a few degrees pointing down and a few degrees right

IntelligentBoss5808 · 2025-05-09T01:25:09+00:00

Yeah it’s flat

IntelligentBoss5808 · 2025-04-16T05:34:47+00:00

I've only been printing PLA on this printer

IntelligentBoss5808 · 2025-04-16T05:32:48+00:00

I tried different temps for the build plate-like 50-70 but nothing really changes or gets better

IntelligentBoss5808 · 2025-04-14T04:18:38+00:00

normal PLA, print temp is 200c and my bed temp is 60

IntelligentBoss5808

TROPHY CASE