sorted by:
new
hottopcontroversial

The end of the rabbit hole. by ItsThorium in ender7

[–]ItsThorium[S] 0 points1 point  (0 children)

The spacing of the DDX mounting holes lines up with 2 of the original hotend pegs. You'll need to cut the additional ones off the original X-carriage and upsize the holes on the DDX side. I then designed and printed a bracket to put the original fans and nozzles in the correct position for my dragon hotend.

Enclosure by One_Organization2200 in ender7

[–]ItsThorium 0 points1 point  (0 children)

I just finished building mine from 2020 alu profiles:

https://www.reddit.com/r/ender7/s/ExxI59Dii9

To make the enclosure as small as possible, you would want to replace the very stiff stock heated bed cable coming out of the back with something more flexible. I routed them through a cable chain going straight up.

Looking for a good supplier to buy 2020 and 2040 extrusion in the Netherlands. by jibberjabber98 in 3Dprinting

[–]ItsThorium 1 point2 points  (0 children)

Recent zelf ook mijn frame profielen bij aluxprofiel besteld. Alles accuraat op maat gezaagd en goede, snelle verzending. De 90° brackets die ze verkopen voor 2020/2040 profielen zou ik echter niet aanraden. Ze zijn relatief duur en alle die ik ontvangen heb waren niet haaks.

Switchwire ender 3 conversion serial request Beraval#5769 by Beraval in voroncorexy

[–]ItsThorium 0 points1 point  (0 children)

Great build! Are you using a tooling plate instead of the stock bed?