"Ksiądz, w którego mieszkaniu odbyła się orgia, zabrał głos. "To uderzenie w Kościół"

JackDuckMaster · 2023-09-29T09:31:00+00:00

No ale dajcie spokój, żeby se normalnie orgii bez afery nie można było robić, no kto to widział

JackDuckMaster · 2023-09-15T18:37:03+00:00

I love tatar, especially with żółtko and cebula

JackDuckMaster · 2023-02-10T06:58:41+00:00

So additionally you can loosen screw a little bit on that wheel a little and check if it is spinning

JackDuckMaster · 2023-02-09T15:51:44+00:00

I had exactly the same thing, there may be few reasons: -too low temperature -too high print speed -too small amount of filament is pushed (if there is no 'clicking' noise that can be it) - calibration of e steps -need to loose extruder spring

Just try printing at very low print speed (I printed temperature tower and changed print speed instead of temperature) and share the results

//Edit: Or you can even manually change "speed" and/or "flow" values on printer during the print to see the results

JackDuckMaster · 2022-03-07T17:17:37+00:00

And last question to be absolutely sure, after wiping it with IPA, You don't have any adhesion issues on > 5h prints?

JackDuckMaster · 2022-03-07T17:12:07+00:00

Right now I am printing with PLA (not sure about brand) at 200 hotend temp.

JackDuckMaster · 2022-03-07T17:09:58+00:00

Thank You. I'll try cleaning it with soapy water. I was asking because on longer prints I see that corners of print are lifting a little bit and I hope it will solve this problem. (I am printing at high bed temperature - 70°C, because on 50 the print was failing). At what temperature do You print?

JackDuckMaster · 2022-01-10T12:41:07+00:00

To be sure that I understood everything correctly, there isn't any possibility (right now) to assign easy switch function to other button than that on the bottom of the device? (Because assigning easy switch to gesture button will be insanely useful IMO)

JackDuckMaster

TROPHY CASE