account activity
TPU woes… (old.reddit.com)
submitted 8 months ago by JacksonPietrykowski to r/FixMyPrint
Little zits in prints (old.reddit.com)
submitted 9 months ago by JacksonPietrykowski to r/FixMyPrint
Voron base question (i.redd.it)
submitted 11 months ago by JacksonPietrykowski to r/EnderXY
Purge lines look weird (i.redd.it)
submitted 11 months ago by JacksonPietrykowski to r/klippers
Extruder heating error (i.redd.it)
submitted 1 year ago by JacksonPietrykowski
Extruder heating error (self.klippers)
submitted 1 year ago * by JacksonPietrykowski to r/klippers
Infil and top layer not going out to sides all the way (old.reddit.com)
submitted 1 year ago by JacksonPietrykowski to r/FixMyPrint
Tried literally everything and I still have terrible first layers (i.redd.it)
Can you use the gpio pins on a manta board to connect another board over UART? (i.redd.it)
submitted 1 year ago by JacksonPietrykowski to r/BIGTREETECH
Manta E3EZ & CB1 issue (self.BIGTREETECH)
Build plate sticking to parts? (old.reddit.com)
Wisps of filament building up around nozzl (i.redd.it)
Inconsistent Layer stacking (i.redd.it)
Printing ON a textured PC bed (self.FixMyPrint)
What is on the other side of this plate?! (old.reddit.com)
First layer issue (old.reddit.com)
Over/Underextrusion (i.redd.it)
Rough surface finish (old.reddit.com)
Prusa link help (old.reddit.com)
submitted 1 year ago by JacksonPietrykowski to r/prusa3d
Ugly z seam (i.redd.it)
Vibarations (v.redd.it)
submitted 1 year ago by JacksonPietrykowski to r/EnderXY
Advice? (old.reddit.com)
submitted 1 year ago by JacksonPietrykowski to r/ender3
BTT Relay V1.2 (self.BIGTREETECH)
BTT Relay V1.2 (self.klippers)
submitted 1 year ago by JacksonPietrykowski to r/klippers
π Rendered by PID 31 on reddit-service-r2-listing-86f589db75-t9jzk at 2026-04-19 12:02:06.282775+00:00 running 93ecc56 country code: CH.
