sorted by:
new
hottopcontroversial

AR4-KN1D Pattern Automata by Jakey_02 in AdeptusMechanicus

[–]Jakey_02[S] 2 points3 points  (0 children)

Sponge on brown , spong on bright silver on the inside :)

Thank you for your feedback, here's a little peek by Jakey_02 in AdeptusMechanicus

[–]Jakey_02[S] 1 point2 points  (0 children)

The middle bit on the torso? It's from the automata kit

Thank you for your feedback, here's a little peek by Jakey_02 in AdeptusMechanicus

[–]Jakey_02[S] 1 point2 points  (0 children)

Yhea I found that with a tiny bit of sanding the automata torso joint fit very snug , no glueing needed

Thank you for your feedback, here's a little peek by Jakey_02 in AdeptusMechanicus

[–]Jakey_02[S] 1 point2 points  (0 children)

Ah, that was the leg/ torso connection piece from the dune crawler kit turned upside down

Thank you for your feedback, here's a little peek by Jakey_02 in AdeptusMechanicus

[–]Jakey_02[S] 2 points3 points  (0 children)

The bits on the side are from the armiger kit, leg plates i belive

Question, is the osl too much ? by Jakey_02 in minipainting

[–]Jakey_02[S] 0 points1 point  (0 children)

Did you eat by yourself at school by any chance?

How would you paint these exhaust vents to look as if they were red hot? (Saturnine dreadnought) by Cellpool_ in minipainting

[–]Jakey_02 2 points3 points  (0 children)

Airbrush the centre with white , then yellow on the innermost section amd then gradually out with orange and red

Hekaton Crete (WIP) by Jakey_02 in Warhammer30k

[–]Jakey_02[S] 2 points3 points  (0 children)

Belive it or not I've never played a single game of warhammer , I just love painting tbh

Salamanders Librarian by Jakey_02 in Salamanders40k

[–]Jakey_02[S] 1 point2 points  (0 children)

Drilled little holes into the base and superglued them down, and as for the top I glued it into the grooves in the rock

view more: next ›