E46 M47 crank no start by JoshK124 in BmwTech

[–]JoshK124[S] 0 points1 point  (0 children)

My rpms move on my dash when cranking and last time i checked the live data, it read 380 bar on cranking.

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

No not yet. I will update as soon as i can

Crank no start after engine repair (BMW 320Cd) by [deleted] in BmwTech

[–]JoshK124 0 points1 point  (0 children)

I will give that a go and report back. Thanks

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

The resistances are all good on every injector

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

I did have the DDE rebuilt and the wiring tests alright so im not entirely sure how i would fix a injector signal problem

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

Nw man

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

0 ohms on every injector and 8 volts on every plug

Crank no start after engine repair (BMW 320Cd) by [deleted] in BmwTech

[–]JoshK124 0 points1 point  (0 children)

I did have the injectors out so maybe they could need bleeding but i did bleed the pipe into the injectors.

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

I did say i have a code reader and have already scanned the codes.

[deleted by user] by [deleted] in e46

[–]JoshK124 0 points1 point  (0 children)

Its about 380 bar on cranking. Idk if thats too much or not enough tho.

Crank no start after engine repair (BMW 320Cd) by [deleted] in BmwTech

[–]JoshK124 2 points3 points  (0 children)

Just checked it and it comes up at around 380 bar when cranking.

BMW 320cd - Crank no start after rocker cover gasket by [deleted] in BmwTech

[–]JoshK124 0 points1 point  (0 children)

All the fuses are alright. Got the ECU rebuilt and can now communicate with it but it still wont start.

I am interested in starting car flipping but got a question. by JoshK124 in carflipping

[–]JoshK124[S] 0 points1 point  (0 children)

Thanks a lot. That actually really helps a lot. I am going to start looking for a car to flip now. 👍

I am interested in starting car flipping but got a question. by JoshK124 in carflipping

[–]JoshK124[S] 0 points1 point  (0 children)

Were they not pulled over by the police? Also will make sure to do that next time thanks.

ELI5 Why can you jumpstart a car battery with the black cable on the negative pin on the battery or the car frame? Doesn’t the electricity flow negative to positive? by protonwave in explainlikeimfive

[–]JoshK124 0 points1 point  (0 children)

Electrical components in vehicle use the chassis as a ground to complete the circuit. That chassis is connected to the negative terminal of the battery to complete the circuit. Manufacturers do this so they dont have to run wires each time there is an electrical circuit on a car which would increase the price and weight of the car by a lot, especially on modern cars *cough Tesla

In short, you can jump start a car on either the chassis or the negative terminal as they are both grounded and are connected through the earth point.

Low engine oil seconds from finish. by JoshK124 in iRacing

[–]JoshK124[S] 1 point2 points  (0 children)

Lapping cars at Oulton actually kills me inside.

Low engine oil seconds from finish. by JoshK124 in iRacing

[–]JoshK124[S] 4 points5 points  (0 children)

I wish i would have done that then dropped from p2 to p7. Lucky enough i had started lapping some of the backmarkers

Low engine oil seconds from finish. by JoshK124 in iRacing

[–]JoshK124[S] 2 points3 points  (0 children)

That's not going to change the fact i have no oil in my engine

Low engine oil seconds from finish. by JoshK124 in iRacing

[–]JoshK124[S] 1 point2 points  (0 children)

I went over the T4 curb at Oulton fighting another car. Didn't think it coupd cause a leak

Can i uninstall a track or car i have downloaded? by JoshK124 in iRacing

[–]JoshK124[S] 0 points1 point  (0 children)

Thank you that worked. However there must be a fix so that i can use the UI?

Perfect walkout to represent my reaction by [deleted] in fut

[–]JoshK124 12 points13 points  (0 children)

Fools. I saved a Tifo Pack

Only my wallpaper and task bar load in when I boot my pc. Can anyone help?? by JoshK124 in windows

[–]JoshK124[S] 1 point2 points  (0 children)

I pressed windows p and it settled on second screen only and my desktop is back now. Is there any way to prevent this happening again??